02-10-2018 07:02 PM - edited 03-05-2019 09:54 AM
ADSL PPPoE Static IP Problem
I have CISCO 1841 Router with ADSL WIC, i have configured the PPPoE information and get the internet on the router but the addresses is negotiated, but i have /29 IP Addresses for example
188.99.99.99.15
188.99.99.99.16
188.99.99.99.17
188.99.99.99.19
188.99.99.99.19
and the Gateway is : 188.99.99.99.14
I need this IPs to working on the router also i have dialer0 with auto negotiated IP address and i need the subnet 192.168.2.0/24 redirect to one of this static IPs, and i need to configure the static IPs in connected servers and the private IPs to computers
Thanks in advance
02-10-2018 07:09 PM
Does the router get a negotiated address inside of your /29, or something completely different?
02-10-2018 07:12 PM
NO It's gives another ip in different range
02-10-2018 07:28 PM
02-10-2018 07:31 PM
02-11-2018 03:49 AM
Hi, Some days ago I have faced the same issue in the INDIA with BSNL service provider. After discussion with ISP, I have configured the router as below:
1. Configured Dial-up and get a normal IP from ISP.
2. Make a Look back interface and assigned an IP public IP to loopback.
3. Added a default route toward to default gateway.
4. IP nat outside is added to lookback interface etc.
I will try to get a backup copy of that router and If will get then I will share the correct configuration with you.
Regards,
Deepak Kumar
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: