I've got two Nexus 7010's running HSRP north bound to a pair of ASA's, and BGP south bound to four 6509's.
Is it possible to advertise default route to BGP neighbor (or prefer it via MED), only if the node is HSRP-active?
Essentially the goal is to create symmetry for inbound/outbound traffic.
Only way I can think of so far is via an EEM script, so that when it sees HSRP go active via syslog, it would kick off an action to remove ASN prepend, or reduce MED, and the opposite if HSRP goes standby.
Was wondering if anyone has done something similar w/ a better way.
PRTG system in place running other sensors on the same host, which are working. Ive added syslog receiver sensor and receiving PRTG data from switch that increases drops, errors and warning stats that disappear after a few minutes. Within mess...
Hi, here is an example how to configure IP-NAT, GRE, IPSEC. I've seen plenty of questions and this might be a good solution! (Mostly the use of commands that might remind u) IP NAT======================================================================...
Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2...
Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs...