Alarm in NCS 540 0/RP0-CPU-ADM1166_VOUT_CH7

[jm-barreto]

Greetings 

I got a N540-24Z8Q2C-M and I have an active alarm for a voltage sensor with value 0 0/RP0-CPU-ADM1166_VOUT_CH7.

Can this issue could cause more problems in the future? Or this could be an indication of hardware problems and I need to replace the box?

I will appreciate any information that you can provide.

[Enes Simnica · Accepted solution]

gDay @jm-barreto A 0-volt sensor reading isn’t normal. Even though it’s a minor alarm, it can point to early hardware issues and may get worse. Best to open a TAC case, and they’ll confirm if the chassis or RP needs replacement.....

hope it helps and good luck!

-Enes