cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

232
Views
0
Helpful
4
Replies
Highlighted
Beginner

Allowed vlan command through a access port

Can anyone explain me that is it possible to allow multiple VLAN in a single access port ? If answer is yes then which circumstances it is possible.

4 REPLIES 4
Highlighted

I understand that it is

I understand that it is Possible to permit 1 Data VLAN and 1 Voice VLAN per Access Port. Would be willing to learn other wise.

Out of curiosity May i request you to show me the Output for

sh int GigabitEthernet1/0/19 trunk

Highlighted
Beginner

Is there a reason why you

Is there a reason why you want to have the connection to switch BF-TL-SW03 be an access connection?
It would be best to have that as a trunk link. 

Highlighted
Beginner

I guess that you would lwant

I guess that you would want to setup dot.1q mode(QinQ) in this interface, do you? If yes, you can configure this interface like the below:

interface GigabitEthernet1/0/19
 description daisy-chain Connection to switch BF-TL-SW03
 switchport access vlan 20
 switchport mode dot1q-tunnel 
 storm-control broadcast level 2.00 1.00
 storm-control action trap

And you also need configure interface connected to G1/0/19 ON BF-TL-SW03
interface GigabitEthernet x/x/x
  switchport mode trunk
  switchport trunk allowed vlan 10,11,15,20,25,30,100

HTH

David

Highlighted
Beginner

What will be the correct

I am not satisfied with the answer provided below. Can anyone clarify same with proper manner.