cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
473
Views
0
Helpful
2
Replies
Highlighted
Beginner

ASA 9.2.2 BGP - allowas-in missing?

Hi,

 

I recently upgraded a pair of 5515-Xs to 9.2.2 for BGP functionality but found that allowas-in doesn't appear to be a valid command.  The ASAs are in a data center outside of the country so there's no point to point/MPLS connectivity, just using the service providers network, and allowas-in is required as far as I can tell with my other POPs in the states.

Am I missing something, or was this command indeed left out?  Is there a work around possibly and still use the ASAs?

 

Thanks.

2 REPLIES 2
Highlighted

Hello, Nate.Allowas-in is not

Hello, Nate.

Allowas-in is not supported on ASA (at least on 9.2.1):

http://www.cisco.com/c/en/us/td/docs/security/asa/asa92/configuration/general/asa-general-cli/route-bgp.html

Highlighted
Beginner

Re: ASA 9.2.2 BGP - allowas-in missing?

i know this thread is years old...

* just as an update

a) ASA Release 9.9 - still no allowas-in

https://www.cisco.com/c/en/us/td/docs/security/asa/asa99/configuration/general/asa-99-general-config/route-bgp.html

b) BGP intelligence must be placed somewhere else, for example as-override:

https://community.cisco.com/t5/service-providers-documents/bgp-pe-ce-routing-protocol-overview-in-mpls-vpns-part-ii/ta-p/3143007#toc-hId--765071651