06-17-2013 05:16 AM - edited 03-04-2019 08:13 PM
Is there any way to prioritize ASA's failover and stateful traffic in the campus network?
Solved! Go to Solution.
06-18-2013 01:38 AM
I would suggest configuring QOS on the layer 2 switch that the ASA failover link terminates on incoming and implement the QOS on the outbound interface across the 10Ge link.
Simon
06-17-2013 03:07 PM
Why would you need to? You mean qos? Not sure why!
Sent from Cisco Technical Support Android App
06-18-2013 12:18 AM
Yes for qos, to prioritize this traffic over long distance 10 GE link.
06-18-2013 01:06 AM
Is the 10Ge link saturated and causing drops on the links? If not then there's no point as QOS only takes effect when there is queueing on the links.
If it is saturated then are you stretching too many vlans over the link, this will cause too much broadcast traffic over it? You might want to look at changing to point to point layer 3 link instead.
Simon
06-18-2013 01:18 AM
Hi Simon,
The 10 GE link is not saturated at the moment. I would like to have qos configured for that link as the measure of precaution.
Best regards,
Vesna
06-18-2013 01:38 AM
I would suggest configuring QOS on the layer 2 switch that the ASA failover link terminates on incoming and implement the QOS on the outbound interface across the 10Ge link.
Simon
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide