05-05-2022 06:30 AM - last edited on 06-04-2022 03:27 AM by Translator
Hi,
I cannot enable otv convergence timers aggressive command on our Cisco ASR 1000. It says invalid command.
Router(config)#otv convergence timers aggressive
^
% Invalid input detected at '^' marker. Show version> Cisco IOS XE Software, Version 16.03.03
Cisco IOS Software [Denali], ASR1000 Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 16.3.3, RELEASE SOFTWARE (fc3)
Technical Support:
Copyright (c) 1986-2017 by Cisco Systems, Inc.
Solved! Go to Solution.
06-03-2022 03:51 AM - last edited on 06-04-2022 03:28 AM by Translator
To enable it:
Router#conf t
Router (config)#service internal
Router (config)#otv convergence timers aggressive
05-05-2022 06:53 AM
Looks like time command not accepting Global level.
check otv ?
or try interface overlay level ?
05-05-2022 06:02 PM
06-03-2022 03:51 AM - last edited on 06-04-2022 03:28 AM by Translator
To enable it:
Router#conf t
Router (config)#service internal
Router (config)#otv convergence timers aggressive
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: