ASR 1002 with IOS 12.2(33)XNF1 Percentage based traffic shaping
Does anyone have problem with ASR 1002 in configuring Percentage based traffic shaping I have following config? Somehow I am not able to attach the swrvice policy to tunnel interface. CLI throw following error.
"Traffic Shaping feature is not supported in user defined class of parent level policy" CEF is enabled globally and I also tried applying service policy after configuring "qos-preclassify". Is there anything special about ASR 1002 for traffic shapping configuration?
On physical interface there is no issues in applying this policy-map.
! class-map match-all Bandwidth_Control_to_Store_CLASS match access-group name Bandwidth_Control_to_Store_ACL ! ! policy-map Bandwidth_Control_to_Store_POLICY class Bandwidth_Control_to_Store_CLASS shape average percent 50 ! interface Tunnel780 bandwidth 1500 ip address 10.56.63.245 255.255.255.252 ip tcp adjust-mss 1436 ip ospf cost 50 keepalive 2 3 cdp enable tunnel source FastEthernet0/0 tunnel destination 192.168.22.206 end ! ip access-list extended Bandwith_Control_to_Store_ACL permit ip host 172.18.128.242 any
interface FastEthernet0/2/0 ip address 192.168.16.2 255.255.255.252 speed 100 no negotiation auto end
PRTG system in place running other sensors on the same host, which are working. Ive added syslog receiver sensor and receiving PRTG data from switch that increases drops, errors and warning stats that disappear after a few minutes. Within mess...
Hi, here is an example how to configure IP-NAT, GRE, IPSEC. I've seen plenty of questions and this might be a good solution! (Mostly the use of commands that might remind u) IP NAT======================================================================...
Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2...
Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs...