cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1757
Views
0
Helpful
5
Replies

ASR 901 SVI based EoMPLS

wandal
Level 1
Level 1

Hi,

I'm trying to configure SVI based eompls on the 901, and this is the error I get:

interface GigabitEthernet0/5

service instance 202 ethernet

  encapsulation dot1q 202

  rewrite ingress tag pop 1 symmetric

  bridge-domain 202

ASR-901-TEST(config)#int vlan 202

ASR-901-TEST(config-if)#x

ASR-901-TEST(config-if)#xconnect ?

  A.B.C.D  IP address of peer

ASR-901-TEST(config-if)#xconnect 10.20.4.15 15 enc

ASR-901-TEST(config-if)#xconnect 10.20.4.15 15 encapsulation m

ASR-901-TEST(config-if)#xconnect 10.20.4.15 15 encapsulation mpls

The Vl202 a vlan interface - command rejected.

The box is running asr901-universalk9-mz.152-2.SNI code.

I realise you can configure the xconnect on the EFP but we were looking to have multiple EVCs share one bridge domain and do the xconnect on the SVI.


Am I missing something or is this feature not supported on the current code?

Thanks.

5 Replies 5

manib
Cisco Employee
Cisco Employee

Hi Alfred,

We don't support xconnect with ASR901 on SVI.  In fact we implemented the CLI error message while attempting to do so.  We support on EVC and port only.

Cheers,

/Mani

Hi Mani,

Thanks for your reply.

Do you know whether there are any plans to have this feature supported in future code or is it a hardware limitation?

Regards,

Alfred Wandati.

manib
Cisco Employee
Cisco Employee

Hi Alfred,

We won't have this on ASR901's radar, and in fact we implemented error message mechanism to alert our

customers.  Its a ASIC and feature limitation on ASR901 alone. 

Cheers,

/Mani

Hi Mani,

Thanks for the clarification, we'll just have to work with the xconnect on the EVC.

Regards,

Alfred Wandati.

gjaimes
Level 5
Level 5

HI guys,

Do you have any news about supporting SVI based EoMPLS on ASR901?

 

Thanks,

 

 

Review Cisco Networking for a $25 gift card