cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
628
Views
0
Helpful
4
Replies
Highlighted
Beginner

Assigning multiple ADSL to GE ports

Hi,

I have problem with router and I was wondering if someone can help me.

I have 1 x C2900 router with 3 x ADSL WIC and UC500. I setup 3 x ADSL to access internet and UC500 is connected with 3 telephone lines (plugged into FXO ports). I have 2 x GE on my 2900. 1st GE is connected to switch and 2nd GE is connected to UC500.

I want to setup that traffic from UC500 (SIP) is going through 1 dedicated ADSL line and data (from computers & servers) is going through remaining 2 interfaces only. Can someone tell me how I can set it up.

I would also like to know how I can load balance internet connection going through 2 dedicated data ADSL lines.

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Hall of Fame Master

4 REPLIES 4
Highlighted
Hall of Fame Master

Highlighted

Yes I tried to find it but I never used PBR and I wasn't even sure how to descibe what I'm looking for. But your answer was spot on. Thanks.

Highlighted

Thanks for the nice rating and good luck!

Highlighted
Beginner

Hi, I use this configuration:

Router (g0/1) ---------- (f0/1) Switch

Switch (f0/2) ---------- (eth) ADSL Modem

Switch (f0/3) ---------- (eth) ADSL Modem

:: ROUTER CONFIGURATION ::

interface GigabitEthernet0/1

no ip address

ip virtual-reassembly

interface GigabitEthernet0/1.301

description MODEM-01

encapsulation dot1Q 301

no ip redirects

no ip unreachables

no ip proxy-arp

ip virtual-reassembly

pppoe enable group global

pppoe-client dial-pool-number 1

interface GigabitEthernet0/1.302

description MODEM-02

encapsulation dot1Q 302

no ip redirects

no ip unreachables

no ip proxy-arp

ip virtual-reassembly

pppoe enable group global

pppoe-client dial-pool-number 2

interface Dialer1

ip address negotiated

ip flow ingress

ip flow egress

ip nat outside

ip virtual-reassembly

encapsulation ppp

ip tcp adjust-mss 1452

load-interval 30

dialer pool 1

dialer-group 1

ppp authentication pap chap callin

ppp chap hostname

ppp chap password

ppp pap sent-username password

no cdp enable

interface Dialer2

ip address negotiated

ip flow ingress

ip flow egress

ip nat outside

ip virtual-reassembly

encapsulation ppp

ip tcp adjust-mss 1452

load-interval 30

dialer pool 2

dialer-group 1

ppp authentication pap chap callin

ppp chap hostname

ppp chap password

ppp pap sent-username password

no cdp enable

:: SWITCH CONFIGURATION ::

interface FastEthernet0/1

description Router

switchport mode trunk

interface FastEthernet0/2

description Modem-1

switchport mode access

switchport access vlan 301

interface FastEthernet0/2

description Modem-2

switchport mode access

switchport access vlan 302

Bye!