The CE should tag the frames with two vlans (one management, one production).
I am planning to use xconnect on sub ATM interfaces to the VPLS on the backbone.
I have 2 issues:
1-the CE1 will tag the frames with a vlan that is different from the VPLS vlan. for example CE1 tag frame with vlan 2004 and xconnect to PE1 in VPLS vlan 4000 at PE2 it is again translated to 2004 but in the response the packet will be forwarded to PE1 with VLAN 4000 and then xconnect to ASR with vlan 4000 and sent in ATM to CE1.
2- is there a way to extract the management vlan from the ATM PVC?
The version of ASR is asr1000rp1-advipservicesk9.03.03.02.S.151-2.S2.bin
Hello guys.I installed remote access VPN on Windows 2019. I need to do additional configuration on the router to allow access outside. I got this.Public IP--------------ISP Router-------------Fa0/0 Cisco Router Fa0/1------------------------My Server ...
Meet the Authors video - How to Troubleshoot Network Problems with Vinit Jain
(Live event – Wednesday, February 12th, 2020 at 10:00 a.m. Pacific / 1:00 p.m. Eastern / 7:00 p.m. Paris)
This event had place on Wednesday 12th, February 2020 at 10hrs PDT&nbs...
I have a pair of 3945 routers that are proving to be underpowered for the 100+ remote offices connecting to them. Fortunately I happen to have a couple of 4351 ISRs rated for significantly greater encrypted throughput. Is there any way I could upgrade the...
This article assumes you have the basic knowledge and experience with Cisco DNA Center and Identity Services Engine (ISE).Note when reading this doc the "Authentication Policy" referred to is part of Cisco DNA Center Onboarding section and ha...