Re: Auto-failover mode

Yogeshraje · ‎10-09-2023

Hi All, I want to configure data, voice traffic on one link and cctv traffic on the second link with auto-failover mode. If anyone could help.

balaji.bandi · ‎10-10-2023

There is good example start with : (and tweak as you like)

https://www.balajibandi.com/?p=1643

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Yogeshraje · ‎10-10-2023

Hi Balaji, Will check and let yu know , Thank you.

Joseph W. Doherty · ‎10-10-2023

Since you want to mix data and VoIP on one link, and in a link failure situation, might mix data, VoIP and CCTV, I would think QoS is a "must". If so, and especially in the case of a link failure, where all traffic is using one link, have you considered just using QoS and allowing all flow kinds to use both links?