Hi All,
I have an E1 network module (NM-2CE1U=) in my router (c3640).
I configured a leased line from timeslot 1 to 30.
The question is why the router says this:
Available Bandwidth 1440 kilobits/sec
the controller config:
controller E1 3/1
channel-group 1 timeslots 1-30
the interface config:
interface Serial3/1:1
description 1920 kbps
bandwidth 1920
ip address 192.168.11.29 255.255.255.252
no ip route-cache cef
no cdp enable
sh int ser3/1:1
Serial3/1:1 is up, line protocol is up
Hardware is DSX1
Description: 1920 kbps
Internet address is 192.168.11.29/30
MTU 1500 bytes, BW 1920 Kbit, DLY 20000 usec,
reliability 255/255, txload 67/255, rxload 9/255
Encapsulation HDLC, loopback not set
Keepalive set (10 sec)
Last input 00:00:05, output 00:00:00, output hang never
Last clearing of "show interface" counters 20w0d
Input queue: 0/75/4029/0 (size/max/drops/flushes); Total output drops: 10429
Queueing strategy: weighted fair
Output queue: 0/1000/64/4799 (size/max total/threshold/drops)
Conversations 0/23/256 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 1440 kilobits/sec
5 minute input rate 69000 bits/sec, 39 packets/sec
5 minute output rate 505000 bits/sec, 74 packets/sec
14033195 packets input, 472113071 bytes, 0 no buffer
Received 51780 broadcasts, 279 runts, 0 giants, 0 throttles
4032 input errors, 2538 CRC, 1497 frame, 0 overrun, 0 ignored, 263 abort
20795275 packets output, 497192000 bytes, 0 underruns
0 output errors, 0 collisions, 426 interface resets
0 output buffer failures, 0 output buffers swapped out
313 carrier transitions
Timeslot(s) Used:1-30, Transmitter delay is 0 flags
