05-27-2013 12:00 AM - edited 03-04-2019 08:01 PM
Hi Experts,
I am setting up my lab using two 2901 routers which is running on 15.2 IOS.
I am trying to simulate a back to back BRI.
BRI Module: WIC-1B-S/T-V3 (x2) one of each router.
I followed this amazing document to understand the concept of BRI and configuration.
http://www.cisco.com/en/US/tech/tk801/tk133/technologies_configuration_example09186a0080094cd6.shtml
but it never says if i can use the module that i have mentioned.
Q1. Could anyone explain what cabling i need to use to setup back to back BRI using 2x 2901 routers with these modules?
Q2. What cabling do i need to use.
Q3. Is it actually possible to use these 2 modules alone to simulate a back to back BRI..?
Thanks.
--
Regards
Tango
Solved! Go to Solution.
08-20-2013 03:23 AM
Use a normal BRI B2B cable. 4 Cables are used.
Side A: 3456
Side B: 5634
Rest are answered here:https://supportforums.cisco.com/message/4003038#4003038
05-27-2013 04:20 AM
What is the poinjt to do that?
These modules do not even support voice at all.
05-27-2013 04:28 AM
guess my first post was in the wrong section of the forum.
how did you find out they cannot be used for voice..?
I want to use them as a back up link for data.
Thanks.
05-27-2013 04:31 AM
For data questions post in "infrastructure - WAN and routing". You can move your post using the actions panel on the rigth.
05-27-2013 04:33 AM
How do you know this is not supported for voice..?
05-27-2013 05:00 AM
By reading documentation.
05-28-2013 12:58 AM
Do you know if the Back to Back BRI is possible with just these two modules..?
08-20-2013 03:23 AM
Use a normal BRI B2B cable. 4 Cables are used.
Side A: 3456
Side B: 5634
Rest are answered here:https://supportforums.cisco.com/message/4003038#4003038
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: