Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
368
Views
0
Helpful
1
Replies

back-to-back

korbenda11as
Level 1
Level 1

‎02-07-2008 01:31 AM - edited ‎03-03-2019 08:36 PM

I have attached a diagram for the connection that I've made for my four routers. A and B were connected using serial ports via frame switch using smart cables. Now, I am short of serial cables for my third router C. I connect router C using cross RJ45 cable, is it possible? what will be my configuration? For A and B i used ospf as my routing protocol, which is not a problem. Can anyone suggest any alternative connection. thanks

Labels:
18643-frame.vsd
0 Helpful
1 Reply 1

owillins
Level 6
Level 6

‎02-13-2008 07:25 AM

use an RJ-48c connector

RJ48 has a keyed connector and a notched jack.

RJ45 does not have a key or a notch.

Both have 8 pins.

Although an RJ45 connector fits an RJ48 jack, the key on an RJ48 connector does not allow it to plug into an RJ45 jack.

0 Helpful
Customers Also Viewed These Support Documents