08-08-2005 01:06 AM - edited 03-03-2019 10:13 AM
I have 1 unit of Cisco Catalyst 2950 switch.
1 PC connected to port 23 and another one
connected to port 24.
hostname switchA
int fa0/23
bandwidth 128
!
int fa0/24
bandwidth 128
!
when i am doing a ftp, I found out that the
speed is more than 128k? why?
08-08-2005 01:19 AM
Hi,
Bandwidth command is used only for communicating the interface bandwidth value to higher lever protoclos. eg: Routing protols which use bandwidth as a parameter for calculating metric takes this value if configured.
This command won't affect the actual bandwidth of the physical interface.
HTH
Regards,
Shijo George.
08-08-2005 10:54 PM
Hi;
If you want to limit the traffic 128K on FE port, then you may use Committed Access Rate definitions such as;
rate-limit input 128000 16000 32000 conform-action transmit exceed-action drop
rate-limit output 128000 16000 32000 conform-action transmit exceed-action drop
This conf. will limit the traffic
HTH
Regards,
Baris.
08-08-2005 11:15 PM
Can this command supported by Cisco Catalyst 2950 with standard image?
08-08-2005 11:52 PM
Hi;
I missed the part that you use 2950 switches. As it is L2 switch, this conf. does not work on it besides there is not such a support with standart images as far as i have known. You may limit the bandwith on L3 side via CAR.
Regards,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide