Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Don't miss this Cisco Catalyst 8000 offer

 
Labels

Forum Posts

Finding accurate answers to your questions and issues is always gratifying, but what if these answers are shared globally across different languages? The Cisco Community team has been working on a proof of concept (PoC) to take Accepted Solutions in...

translator.png Asolution.png htlm-source.png insertcode(1).png
Kelli Glass by Community Manager
  • 10275 Views
  • 7 replies
  • 16 Helpful votes

Hi Experts,Basic question regarding the ISIS process. If I have a default config of ISIS between simple two IOS-XR routers:In this case both level-1-2 will form neighbor relationship.RP/0/RP0/CPU0:test1#sh run router isisrouter isis ISIS-COREnet 49.0...

Hello everyone!We have ASR1001x with fullview and ipsec tunnels. We use local policy to forward packets from PA addresses to their respective gateways. When the traffic load is high PBR stop working and the router starts using cef, when there is litt...

shados by Level 1
  • 132 Views
  • 8 replies
  • 0 Helpful votes

hi,will be using GLC-LH-SMD SFP in one of our ASR router.just need an advice on which type of fiber patch cord to use.the telco will run a SM fiber in their rack which is in another room, all the way to our DC rack which the patch panel hand off is L...

Assume that there are three router type devices outside firewall, and one core switch router behind one layer firewalland I would like to hide the router hop of core switch router from traceroute how to modify TTL to less values at router at the most...

Maivakov by Level 1
  • 499 Views
  • 8 replies
  • 0 Helpful votes

I have Two ASR 1001 but failover for return path doesn't workWorks fine leaving from firewall to ISP Problem when ISP trying to find firewallHSRP active R1 but Internet goes down by BFDtracert says ISP to router 2 10.10.10.2 than die finding to firew...

MonkeyBear007_0-1711426962436.png

Hello We have ASR 1006X With software image 17.9 How to verify that it will support IPSec configuration? Is it related the rouer image or the license? Please note that, currently we didn't have access to it to verify using command line

Hi There,i am struggling a bit with our BGP Configuration and hopefully someone can give me a hint to right direction.We have 3 Routers in iBGP each of them has a WAN Connection to external AS (eBGP).Currently all Traffic is routed to only 1 external...

AS789 by Level 1
  • 378 Views
  • 7 replies
  • 1 Helpful votes

Hi guys,I try to configure IPv6 with EIGRP for my topology; for some reason, the EIGRP routing table isn't learning the IPv6 subnet from its neighbor When I run 'show ipv6 route interface t0/0/0' on the router side and 'show ipv6 route interface e1/1...

Can someone explain what this configuration is doing, at a high-level, I am just trying to understand what is going on here?  The route-map statements 20, 30, and 40 really don't do anything, correct? CPE-1 Configurationrouter bgp 2152neighbor casc-d...

eagleeye_0-1710635550725.png
eagleeye by Level 1
  • 466 Views
  • 8 replies
  • 0 Helpful votes