Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

 
Labels

Forum Posts

Hello all,Is it possible to have a route that failover to another ISP2/Connection in the aftertoon from the main ISP1 which is regular. So, I have 2 Towers in same location, both having different ISP. Tower2 is residential and often less busy in the ...

Hi,I have a core switch 6509 on core. It has many SVI for intervlan routing. we have defined a vlan on it for guest (vlan id 202)  with no svi defined on it. A port in access mode in vlan202 is connected to a separate ISP ONT for internet connectivit...

Wonxie by Level 1
  • 395 Views
  • 13 replies
  • 1 Helpful votes

Hi Guys, I'm trying to config macsec between cisco 4500 and AWS. On the 4500 it's seems that i don't have all commands. like under mka policy, i dont have macsec-chiper-suite or key-server... Software: cat4500e-UNIVERSALK9-M Version 03.08.01.E with e...

Adanio1 by Level 1
  • 261 Views
  • 4 replies
  • 0 Helpful votes

Hi everyone,hope you can help with EIGRP unequal load balancing in a Catalyst 3650. I have a system where I need to send the traffic to reach the 10.1.40.0/24 via the vlans 4084 and vlan 4087. Due to the metric, the vlan 4084 as the lowest FD and vla...

Othacon_1-1706718405001.png Othacon_2-1706718435594.png Othacon_0-1706718361959.png
Othacon by Level 1
  • 652 Views
  • 18 replies
  • 1 Helpful votes

Hi all,Need some help. I have a cisco 3845 connected to a 3750 switch. I am unable to ping external addresses directly from either the 3750 switch or 3845 router without a source address. Amel-router#ping 8.8.8.8Type escape sequence to abort.Sending ...

Adam_S by Level 1
  • 3217 Views
  • 25 replies
  • 0 Helpful votes

Hi everyone and thanks in advance for any help. Im making a demo network and have this core switch connected to a fortigate on one side and an access switch on another. I am having connectivity issues so im trying pings. the default gateway is the fo...

Resolved! VTP Password

Hello,Why when exec 'show vtp password' the router responds with 'vtp password is configured' and not showing original password?Currently i use C9300 with SW version 17.09.03

hs08 by Spotlight
  • 397 Views
  • 6 replies
  • 0 Helpful votes

Need some help with 9300 Static Routing.   We have a stacked 9300 being used as a collasped core with all of our VLANS on it. Each VLAN has an SVI and IP routing is enabled.  We also have a gateway of last resort set of the firewall that is connected...

The 9407 and 3750 are direct connect.SSH access fails due to an algorithmic issue.Please advise. 9407# C9407#ssh -l admin 192.168.10.10 [Connection to 192.168.10.10 aborted: error status 0] C9407# Jan 18 10:39:49.478: %SSH-3-NO_MATCH: No matching kex...