Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

 
Labels

Forum Posts

i try to install it on kali but this error still exist  The following packages have unmet dependencies: packettracer: Depends: libgl1-mesa-glx but it is not installable

Bonjour,J'ai un VLAN bureautique en 192.168.1.0. Mon CBS350-8T-E-2G a l'adresse 192.168.1.240.La passerelle par défaut est le 192.168.1.1.J'ai un VLAN formation en 192.168.80.0. Mon CBS350-8T-E-2G a l'adresse 192.168.80.1, le dhcp fonctionne parfaite...

Resolved! BGP and Loopback

 Hello,I was able to reach ank_linux computer from ist_linux computer, I created loop back interface on both routers, now I can't reach ank_linux computer from ist_linux computerany suggestions? 

CISCOLOG by Level 1
  • 263 Views
  • 5 replies
  • 0 Helpful votes

Hi Guys,I have 2 pairs of Nexus switches, each pair at each location. They connect between 2 locations with 2 x layer 3 links, as shown in the diagram.I configured EIGRP routing for both sites for these 2 pairs. The EIGRP routing works; my question i...

I have the following connectivity:CE - CIG IPSEC tunnel which is up and i can hop across from Cig to CE.BGP neighbor relationship betwenn CE and CIG resets every 3 minutes.  I have tried bouncing the tunnel and clearing down to the crypto etc but not...

Do I have to redist for the BGP to have Rib and there is no around itrouter ospf 100passive-interface GigabitEthernet1network 3.3.3.3 255.255.255.252network 10.1.2.0 0.0.0.255 area 0!router bgp 100bgp router-id 3.3.3.3bgp log-neighbor-changesnetwork ...

jamesbefreedeer_0-1710198143087.png

Hello, i have Cisco router 3945, working well, when i reboot or after electricity goes down internet doesn't working, i should go to router do shutdown and no shutdown after internet will working.why does this happen thanks in advance 

Mlex1 by Spotlight
  • 442 Views
  • 15 replies
  • 1 Helpful votes

My names Terry, I'm a bit new here and new to Cisco ACI.Wanted to ask a question about L3Out within the Logical Node ProfilesI have ipsec tunnel between 2 palos that are connected to my fabric. (before my time )The Palos are connected to two BL's wit...

Hi team,Here is my topology,  apparently sw0 and and core sw 1 have eigrp as 10 between them. core sw 1 has knowledge of the rest ospf network. i have redistibuted eigrp 10 on ospf 30 and ospf 30 on eigrp 10.sw0 sees core sw 1 as eigrp ne, but has no...

fmugambi_2-1710412051459.png
fmugambi by Spotlight
  • 208 Views
  • 14 replies
  • 0 Helpful votes

Hello team, attached is my problem statement diagram.I need 192.168.100.0/24 to talk to aws servers - 10.100.100.0/24.my issue is, traffic from 192.168.100.0 to aws cloud tends to pass via mpls to site A, which is not the intended route, so i had to ...

fmugambi_0-1710321852735.png
fmugambi by Spotlight
  • 224 Views
  • 8 replies
  • 0 Helpful votes

When i configure one of ethernet interfaces on ASA 5510 as DHCP client it obtaines the lease from DHCP server but it does not release the lease even if i disconnect the interface from the network it stays in "RENEWING" state and show it in ASDM DHCP ...

msubtain by Level 1
  • 4829 Views
  • 4 replies
  • 0 Helpful votes