Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

 
Labels

Forum Posts

Hello all!A small disclamer here, i am completely new to the cisco environment. And therefore this is my first ever configuration to a cisco router. The router is a ISR-1100 series.I have tried following the start guides and basic configuration, but ...

Hevos93 by Level 1
  • 67 Views
  • 0 replies
  • 0 Helpful votes

Hello Everyone, I want to create different NAT rules for the same source based on the destination. Assume that I have the private range 10.0.0.0/8 and I want to create two NAT rules as follows:if range 10.0.0.0/8 wants to reach ACL1 then use the publ...

Ali Hazim by Level 1
  • 140 Views
  • 2 replies
  • 0 Helpful votes

Hi dear experts,I am having problems to configure and a lack of understanding the technique.My setup: ISP via DOCSIS to modem (in bridge mode) to the RV260 router. Behind the RV260 are a Catalyst 9115 and several Clients connected by LAN (1GB copper)...

familieboehler_0-1708856872819.png familieboehler_1-1708857123370.png familieboehler_0-1708857975427.png familieboehler_1-1708858382029.png

I have three WANs; one is the primary and the other two are backups. Primary = dhcp; Secondary = Cellular0/2/0; Tertiary = Dialer1The routes are as follows:ip route 0.0.0.0 0.0.0.0 dhcpip route 0.0.0.0 0.0.0.0 Cellular 0/2/0 251ip route 0.0.0.0 0.0.0...

emuman100 by Level 1
  • 445 Views
  • 15 replies
  • 0 Helpful votes

Hello everybody!In a Lan - Wan - Lan network topology, the following problem is occurring:When I send the PDU from Lan 1 to Lan 2 it fails.From Lan 2 to Lan 1 is successful the second time.How can this problem be solved?

la-la by Level 1
  • 133 Views
  • 1 replies
  • 0 Helpful votes

HelloInfo:Hardware: ASR-9901-RPVersion: 7.1.3We are an open fibre provider with several white-label ISPs. The problem or rather question we are facing right now is the following.As we only have one border connection to internet at the moment and each...

tojo2002 by Level 1
  • 4535 Views
  • 15 replies
  • 0 Helpful votes

Hello Experts @balaji.bandi  @Rob Ingram  This may be not the right place but appreciate your support here.I have two Hubs in Azure in two different regions named east and west. East hub has BGP within express route and act as transit for all underly...

Hi All,  I'm currently stuck on wondering why l2tpv3 is up but traffic don't forward and my target to extend Vlan from 1 router to another doesn't work In attaching the configuration but basically, I have two industrial IR1101 with LTE module. Throug...