Finding accurate answers to your questions and issues is always gratifying, but what if these answers are shared globally across different languages? The Cisco Community team has been working on a proof of concept (PoC) to take Accepted Solutions in...
ASA working in IPSec, I am able to access HQ from UNIT No problem. Internet is only allowed on specific IPs which are outside DHCP Scope. When I assign IP for internet, now Internet is working, HQ Network is accessible, but S_EXT (webserver - 10.10.1...
Hello,I need your help - currently we have a 2921 Cisco router connected to dual ISPs using "gi0/0 & gi0/1" and we are able to connect to either ISP successfully. Once we connect gi0/2 to any device the connected switch is not able to access the in...
hi,i'll be changing an ISP/BGP peer. my question is, do i negate first the old bgp router-id or just directly configure/apply the new router-id?do i need to do a "clear ip bgp" to establish the new ISP/BGP peer?router bgp 65123 neighbor 63.21.16.4 sh...
Have applied the below policy map in OUT direction but I couldn't see the packets count increased but instead the total bytes output get increases. At the same time policy towards ingress which captures the match protocols increases.Input policy-For ...
If my ISP is logically routing between a routed interface on their end with an IP in the same subnet as my end's Layer 3 router SVI interface for VLAN 10, but the ckt terminates on a layer 2 switched interface on my end using vlan 10, does my ISP nee...
Hi,Is line vty is require when router connect through ssh remotely. If require what will be the command for router N540x .Thanks,Prash
Hi,Is I need to configure line vty connect on cisco n540x router remotely through ssh.If yes please provide the command. This is really help me.Thanks,Prashanth
Hello Community,Just chasing some feedback on the setup that load balances traffic on the both WAN uplinks that are connected to 2 Starlink kits.I know its going to be ECMP using the equal cost but my question is what would be the best implementation...
Hi DMVPN Pros Maybe a DMVPN hero can help me out. I have a DMVPN setup with multiple spokes that are behind the same CGN (mobile 4G network). So there is a possibility that 2 CPEs may have the same public IP address after processing the CGN. Is this ...
Hi, Need Help !!!! How i configure bandwidth limit on IP (not on port) in Cisco 3750 My configuration access-list 150 remark ****************test***********access-list 150 permit IP any xxx.xx.x.xxx 0.0.0.3access-list 150 permit IP xxx.xx.x.xxx 0.0...
Dear Respected Members,I have tried to configure Cisco 2911 Router with EHWIC-VDSL Module for my friend. He is based out of Egypt and His ISP is WE/TEDATA (TELECOM EGYPT)This is the configuration that I did but its not negotiating or authenticating a...
Hi,Can someone please provide me exact command how to configure ssh on cisco N540x router.Thanks,Prash
Hi,please help me how configure ssh in Cisco N540x router. thanksprash
Hi All,I need help from someone who can help me to validate my below tacacs configuration for cisco N540X router.tacacs config on N540x Routertacacs source-interface Loopback0 vrf defaulttacacs-server host x.x.x.xtacacs-server host y.y.y.ykey 0 abcde...
