Routing

I was recommended ME3400EG-2CS-A with METROIPACCESS to use as a router for a project. It appears these switches do not support NAT? Is this correct?   I just want to make sure there is definitely no NAT support on these devices before I arrange to ha...

        I have a pair of cisco nexus 9500 spine switches but not in ACI mode - just straight EIGRP L3 ECMP links to leaf switches.  The spines are cross connected with a dot1Q trunk and so each sees the other as an EIGRP neighbor/peer over a common ...

Hello community,   I'm looking for a restriction for RR Desing but didnn't find  anything. My question is if I can add additional community for the prefixes that are learned from RR-client (iBGP) on the route reflector and advertise them back to the ...

Hi my friends. I want to configure qos in my brach router .   We have 2 Tunnel in branch router and have 2 different Wan Links that hast different speeds and each has a subinterface   fa 0/1.200   ==> 256 Kbps fa 0/2.500  ==> 512 Kbps   I dont know I...

Dear Members: We are planing to replace ESP100 by ESP200 in one of our router [ASR 1009-x] for upgrading the overall througput.  Can anyone please explain the total procedure/dependency in breif or share a good link to start? And we have few specific...

Hi Gigs, 1. Both the Messaging servers in DC1 and DC2 will be Configured with L3 address (IP schema confirmation needed based on solution) 2. Application running on the Messaging servers both at DC1 and DC2 will be configured with single multicast ...

Hey guys, I'm in the process of obtaining my CCNP and I'm currently working with EIGRP and IPv6. For some reason, I cannot receive EIGRP routes into my routing table even though neighborships have been established. Please review the config below an...

I have a remote site connected via a series of Metro Ethernet links with EIGRP routing configured. I now created a GRE tunnel over IPSEC over an internet link as a backup path. MAIN SITE ..................................................................

I have 2900 series legacy router being configured for small office environment with a single ISP connection, and are assigned a single IP address.  I am using 10.0.0.0 network address space sent to a ASA5540 to use PAT with the ASA's outside interfac...

Hello overseas friends   Greeting   Does VXLAN totally replaced OTV/VPLS ?       Thanks all   Ibrahim    

Hello overseas Freinds   Greeting   I have small Queries   router ospf 1 router-id 1.1.1.1    ---->>>I dont have interface with address 1.1.1.1 , but i see it works ,     pls explain   thanks