Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 
Labels

Forum Posts

Hi I have a HQ site and a branch site connected via an ME ISP network. The issue that I have with the two sites is that when I check under the sub-interfaces for the RX and TX load on the HQ they are not the same as that of the branch site. For exam...

Network noobie here. I have recently purchased a RV320 router for my home and have been attempting to get it to work with my home network setup. My home network includes a Cable modem->RV320->POE Switch->Access Points. I have followed the setup guide...

Hi, Iam configuring new ISR4451 router along with SM-X-ES3-16-P service module in CCW. I believe SM-X-ES3-16-P comes with LAN base image which can support static routing. For Layer 3 functionality (RIP etc) , I need to purchase minimum IP Base licens...

navneet.k by Level 1
  • 1834 Views
  • 7 replies
  • 0 Helpful votes

Hi experts,I am doing an experiment to NAT traffic from global VRF to another VRF (called Internet). Please see my diagram. R1 is a host router with default gateway pointing to R2. R3 is simulating the ISP. Its lo0 with IP 3.3.3.3 is simulating an In...

HiWe are using the following image on our production  layer-3 switchIOS (tm) s72033_rp Software (s72033_rp-IPSERVICESK9_WAN-M), Version 12.2(18)SXF11, RELEASE  SOFTWARE (fc1)There is no support for IP SLA in the current  version. But it seems there i...

HI Champs, I am struggling to isolate a problem but not exactly sure if this is related to hardware or Memory issue.. So here is the problem.. Problem - I have Cisco 881 router and have 4M MPLS pipe from provider. I am running QoS across the network...

Hi,     I am seeing below error while apply the labeled-unicast config. Please let me know what is wrong with this config. RP/0/RSP0/CPU0:ios(config-bgp-nbr)#address-family ipv6 labeled-unicastRP/0/RSP0/CPU0:ios(config-bgp-nbr-af)# RP/0/RSP0/CPU0:ios...

Hi all, I work in the service provider industry and recently took on the responsibilities of the transit and peering. I am working through extending the use of communities to control traffic within our business over some current as path filtering and...

Hi folks, I have a cisco 2911 with (C2900-UNIVERSALK9-M), Version 15.2(4)M6a, I can't configure IP SLA monitor for WAN failover. Is this IOS version support IP SLA or there is another way to configure. the options I have is: IP SLA ?  enable     Ena...

Hello All,  I just got a new dedicated internet circuit installed.  I am used to getting MPLS where I only configure the internal interfaces and now with the EDI circuit I was given the WAN ip along with the customer LAN ip's but they are public IP'...

Hi All I have series of question regarding the order of operation of the HQOS configured and shaping applied.interface fa0/0service-policy out level1class level1match <src-dest>Policy-map level1class level1bandwith 2000shape average 2000000service-po...

Hi, We have site with a pair of 2 x 6800 VSS switches connected to a separate carrier using two routers - both running eBGP.  See attached. This carrier is passing us all our global BGP routes (5,000+) via their backbone as they have links into our ...