Routing

can you anybody give me a best practices on setting this up. I think I would use HSRP between the two however suggestions on splitting up BGP and making it redundant would be great. thank you

Hello, I am stuck over a design for route-distribution in hub. DMVPN overlay routing uses EIGRP 400 terminating at two border routers. Routes from legacy wan are distributed into data-center using bgp 65002 on edge routers and then bgp peered to Ne...

Today, we route Internet traffic to our datacenter.  We are going to be doing a pilot at one of our branch offices where we are bringing a broadband connection to offload Internet locally.  What I would like to do is have this setup so that if this c...

Hi I have a dual 4500X VSS setup.  I have one WAN cct on each chassis running BGP.  I have found if I fail the active VSS chassis it takes a significant time for BGP to converge on the standby (now active) chassis.  If I simply fail the each circuit...

Hi, We created "new" SVI interfaces on the core switch, all static routing no dynamic routing.  Switches are all Layer 2 between core and MPLS router.  CORE ---> Trunk ---> L2 Switch--->Trunk--->L2 Switch---Router  Trunks on all switches have new v...

Hi What is relation between CRS and GSR? Anyone can explain it briefly? Thank you so much.

Hi, We have a Cisco WS-C2960X-48FPD-L currently running c2960x-universalk9-mz.150-2a.EX5.bin without issue. For security reasons we are required to update to the latest firmware however when updating, the switch fails to finish booting and hangs at ...

Hi Guys, I have a configuration where in i see multiple spanning-tree features been enabled on a port. I know we use portfast for access ports and root guard between trunk ports. I would like to know how the below port would behave given the config i...

Hi, Traffic shaping P2Pis the subject here. With an ASA 5506 I'm unable to perform traffic shaping, not being able to block P2P connections. I setup an ipfire server which have these features tested and works perfect. The routing is a bit of a challe...

hi, have an ethernet router that needs to use PPOoE to connect to ISP with a set  VLAN. Cannot seem to find any doco on this. Any help?

We have an ASR1002 running the following: OS: Cisco IOS XE Software, Version 03.16.04b.S - Extended Support ReleaseCisco IOS Software, ASR1000 Software (PPC_LINUX_IOSD-ADVENTERPRISEK9-M), Version 15.5(3)S4b, RELEASE SOFTWARE (fc1) ROMMON: 0         0...

1) есть несколько роутеров 29012) поднят Dynamic Multipoint VPN 3) тушу тунель на споках руками (командой shutdown в интерфейсе туннеля) - в бранч офисе доступ к остальным сегментам корпоративной сети пропадает, но интернет работает 4) на хабе меняю ...