Routing

If I have a policy-map that uses 10 different classes but my "priority" class is located at the bottom, is it still scheduled first within an interval?  I would assume it is, but I'm confused because I know that policy-maps are processed in a top-dow...

Hello, Could anybody explain me about sh policy-map control-plane command on c6500? I'm implementing CoPP on my cisco switch. I've created ACLs, class-maps and policy. After that, I entered sh policy-map control-plane CLI command: #sh policy-map con...

I'm in the process of configuring VPN and when i get to configure crypto, the router 1921 does not accept crypto isakmp command .Could it be a probelm with security license?Help Agaba G

Hi All,I want to check the count of the static routes configured in the MPLS PE router under various VFRs.I am using sh ip route vrf vrfname summary to check for each vrf .can anyone please update me on command to find the all configured static route...

Hi, We have large global network using PfR in IOS-XE version 3.13.02s.  When troubleshooting IPSec anti-reply issues we notice that most of our PfR probe traffic is apperaing as DROPPED. Due to the fact that we have issues with stability in the PfR s...

Is it the router that connects 2 different areas or router which has one interface in area 0(backbone area) and another interface in any other area. Thank You ravi

Hi, I tried the following command, It's working just in one way, if WAN-1 Fail on interface Fastethernet 4 the default route switch to the WAN-2 on integrated 3G interface Called Dialer 1. But the problem Is, when the WAN-1 goes back on, the Router...

Hi ,  i am planning to buy cisco 7606 router with 720 3CXL GE switch processor  and SIP 400 module need to know will it support PPPOE or any additional module will be required . we need to have 3000 concurrent PPPOE session . please some one advise s...

Hi All, Hope you guys can help with my problem. Scenario: We want to have a site to site IPSEC VPN connection with our hosting service and also have individual client IPSEC connections to the same host but to a different network within it. Solutio...

hi, I have basic straightforward l2tp/xconenct configuration for transfering L2 traffic through my L3 network. Problem I have is that traffic exiting tunnel is out of order (wireshark says so, traffic is captured witm embended monitor capture ASR se...

Good Day, Please advise what versions of ios are compatible with 2811 and 2851 routers and if they support netflow. Thank you.

After CSCtr26978 : PfR Simplification - Phase 1 -1, effective with Cisco IOS Releases 15.2(1)S, 15.2(3)T, and Cisco IOS XE Release 3.5S, the set mode select-exit command and the best and good keywords were removed. With CSCtr26978, the default behavi...