Routing

Hi Do you think command "ip pim sparse-mode" can work in ASR9K? I typed it under interface, but it cannot work. Anyone can give some suggestions? Thank you

HI please let let me know the probable causes that BGP is not installing alternate path in its table while alternate path is available. Topology attached fyi  and not getting alternate path at R4 .

Hi! To my knowledge, I know that the MPLS protocol limits the bandwidth of an interface to a certain bandwidth according to the model of the router, for example a G0 / 0 interface will not have the 1 Gbps but will have the limit that MPLS establishe...

Hello some of the fast Ethernet ports changed from 100 to 10 Mbps speed. Can i log the information or time when it happens on my ports? i mean can i track those changes and their times when it happens? some command in CLI for that?

WHAT IS THE OUTPUT VOLTAGE OF THE POE PORTS OF SG200-26P  (24 OR 48V)

Hi Experts, I wanted to know if using the command ip pim rp-address x.x.x.x access-list  on the RP can we restrict which source can register with this RP. Most documents speak about configuring the group address for which the RP should be but can an...

Hi, We have a Cisco 4351X with the 8GB Flash upgrade (MEM-FLSH-8G=) & this has been installed. I can't find any good documentation on how to actually transfer an IOS on to the new flash though, as installation of this disables the onboard router mem...

Hi, We have a setup of 2 WAN router from different ISP's connected to one switch. In switch: Routes are configured as ip route 0.0.0.0 0.0.0.0 <Router-A gateway ip> track 20 ip route 0.0.0.0 0.0.0.0 <Router-B gateway ip> 200 track 20 ip route x.x.x...

What is different of cf memory card 256MB, between part number 16-2647-04 and 17-7467-01 ? Is it compatibility ? Thank you

Hi All, Hoping someone can help please. We have a managed office where we use a 4948 (enterprise services) to split the ISP's 1GB internet pipe for each of the business in the building. I've simply split our public range into /28's and added one pe...

Hello guys, This is my first post here. I created a multi-area OSPF topology with one particular area at the edge which I defined as "stub". The stub router received a default route pointing to its neighbour but still its routing table showed all O...

Hi,   I am using ASR1001 with 03.16.03.S code installed I activated the advipservices license and did the reboot as well. For some reason, the license is activated but not enabled   ASR1001#show lice Index 1 Feature: adventerprise                   ...