What's the equivalent device of cisco, compare with juniper MX10. and what's the comparison? why will i use cisco then i get juniper as a very cheap then cisco?
hello all :)
i have a cisco2811
but, fatal(?) problem exec!!
situation this.
consol cable connected - power on - flash memory(64mb, new) - putty
and i see rommon 1 >
but, does not enter any key.
belived? does not enter any key.
i want to use rom...
Hi,
I have attached Show power and Show module command out put of Cisco7609 router. Could you please confirm can we do the power redundancy?
Now the router is working in Power combined mode.
Hi,
I have 4 VRF running in my network and want to understand, does PfR support multi-vrf environment? before implementing in my network.
Thanks & Regards,
Ashwini
Hello!I am using an ASR1001-X as Internet Gateway and it crashes every few days with the fllowing problem:ROM: IOS-XE ROMMONasr1001x uptime is 4 hours, 58 minutesUptime for this control processor is 4 hours, 59 minutesSystem returned to ROM by reload...
Does anybody knows what is this used for?TMT-HE-GW(config)#router ospf 1TMT-HE-GW(config-router)#p?Router configuration commands: passive-interface Suppress routing updates on an interface prefix-suppression OSPF prefix suppression priori...
Hi Experts,
We have a small network having 6 to 10 users and single VLAN. All were using 3Cx soft phone in their machines. Users are complaining about the voice quality so we have upgraded our bandwidth and enabled QOS in the router. But still users...
Hello everyone! I've been trying to forward a port on my Cisco DPC3848VM, but I can not seem to get the rule to save... I've tried a number of things I've found online such as disabling the UPNP and setting up a Static IP, and nothing seems to have ...
We are trying to use a cisco 6901 voip phone on a Juniper SRX240 router. We have been successful with using it on a SRX210 but for some reason will not work on a 240. Does anyone have a possible solution as to why?
We have a Cisco 4331 Router that is not passing connection specific DNS suffix to wireless clients and as such they are unable to authenticate to the Windows Domain. Config:
ip dhcp pool Data VLAN network 192.168.2.0 255.255.255.0 default-router 19...
Hi
Hi what kind of Multicast setup is useful for for a server at HQ needs to send finance information his clients on the same HQ and on another branches
thanks all
I have a Cisco 2901 router that I am doing DHCP with on multiple VLANs and a Windows 2012 server that I am running AD and DNS on but for some reason, the DNS is not staying updated. I have the IP of my server configured as the DNS server on all the w...
Hello friends,
i'm facing a unusual problem...
in my network i have a rendevouz-point and many sources which they're at same time subscribers between them. One, just one, of my subscribers is not a source, only receiver. The problem is, the connecti...
I am a newbie and I am studying for my CCNA Routing and Switching. I realize there are a lot of dumb questions from newbies but that's how we all learn.
I have a 2900xl switch and a 851W router. I have both set up with addresses but cant seem to see...
