Routing

Hi, I have bit of a problem and would appreciate some help. The setup is based on a Cisco 2921 router.The network addresses are just for the example of the situation and what I would like to achieve. There is one inside (let's say the local network ...

Hi Sir,  Please help to answer some questions below. 1. I'd like to get confirmation whether NIM-ES2-4 card can be installed later without powering off the ISR4321 router? 2. is it possible configure HSRP between 2 units of ISR4321 in active-standby ...

Hi Sir,  Please help to answer some questions below. 1. I'd like to get confirmation whether NIM-ES2-4 card can be installed later without powering off the ISR4321 router? 2. is it possible configure HSRP between 2 units of ISR4321 in active-standby ...

Hello everybody, we do have the follow problem. We have 2 cisco ISR4321/K9 (Version 15.4(3)S5). On the backup router the s2s vpn connection is stable and working on the primary router S2S VPN is working sporadically. We have checked everything and ca...

All, I've never done what I'm describing before, and because there may be proprietary information in the actual output, I have to be unfortunately vague, but here's the situation: A customer noticed an asymmetric path through his BGP cloud while inv...

We have a couple of 7606-S / RSP720 core routers, each populated with one X6724-SFP and three X6708 cards, and we're looking to replace them with something else, mainly due to the oversubscription limits of the X6708s being reached more and more ofte...

Hi there, I do not get a link or any activity light on the SFP adapters on CGR2010 router. We have tried different adapters and cables. Any suggestion would help. Thanks, Saurabh Rajpal

Hi, I have a question with a Cisco 1921, working with a VPN interface. Version are: Cisco IOS Software, C1900 Software (C1900-UNIVERSALK9-M), Version 15.1(4)M5, RELEASE SOFTWARE (fc1) The problem are: I have two networks:   - First: (net (172.x.x....

Hi Community,I have a Cisco 819G router which I've setup to use ADSL on the Dialer0/Gigabit0 interface, and 3G on the Dialer2/Cellular0 interface. I've setup a route-map on the VLAN1 interface to load balance the internet connections based on protoco...

Dear Experts, Please see here attached packet tracer 6.2 file (if you do not have Packet tracer then see another JPG file) which have BGP diagram with Configuration. I am confused in each router's  " Neighbour "  and  "Network" commands. So please v...

Hi Folks, Appreciate if you could answer my query regarding the OSPF based default route. WAN of Router A is connecting to primary DC site and WAN of Router B with DR.We are also having one remote site with two routers C & D.Router C is connected to ...

Hello, I am desperately looking for this IOS c7200-adventerprisek9-mz.122-33.SRE14.bin It looks like unfoundable, nor is possible to subscribbe new smartnet. Would anybody be able to help me? thanks in advance

Hi all,I have a cisco metro switch me1200, that is controlled by a ME3600X. I can configure the ME1200 via the Me3600 but I can't find the default username/password. When I try to access the ME1200, via https, it prompts for username/password. The sa...