Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 
Labels

Forum Posts

When I installed an NM-1T3-E3 module in a 3845 Router and did a sho ip interface brief or sho controllers, the module does't appear to be installed; however, upon booting up the router the following information shows: 345 0X000F6400 Clear/Fractional ...

skhirbash by Level 1
  • 4780 Views
  • 7 replies
  • 0 Helpful votes

Hi everybody, I have a topology with DMVPN Hub-&-Spoke (2 spokes). I try to check the recovery of the DMVPN by shutting down the physical interface of the Hub and "no-shut" it, but the DMVPN on one of my spokes (spoke 2) takes really long time to co...

Hi All,   We are looking at setting up a DR data centre that will provide internet edge resiliency as follows:   1) If the primary site internet connection fails, inbound traffic will flow via the DR data centre and over the iBGP link to the primary ...

de1denta by Level 3
  • 531 Views
  • 1 replies
  • 0 Helpful votes

Hi, I have recently migrated from cisco 3845 to cisco 4431. I have a policy map configured to give priority to voice.Post migration i am seeing packet drops on the default class map. fyi, circuit BW is 40Mb. Policy Map Voice_mpls For Voice Class L3...

I was reading on L3 switching .  If I ping from 10.1.1.1 to 20.1.1.1 what happens if it is an L3 switch .I read it does ASIC switching .what are the advantages of using ASIC switching. I am of the opinion if I have an L3 switch as per the topology be...

Hi I have 3 Internet Links One of the link is a Satellite link and is never been used I wish to redirect "only SKYPE" traffic on the Satellite Link Users are connected on interface g0/1 Satellite internet is connected on g0/0 I am using a Cisco 2921...

ASR's CPU & MEM monitoring, Either in realtime or while generating network utilisation reports, our NPM has never generated a correct report on ASR's CPU & MEM.  I would be interested to know additional comments on ways to monitor ASR's CPU & MEM in ...

Hello all, I'm studying about 65xx chassis. The question is below. 1. I'm wondering what's the difference between OIR and Hot swap? I guess OIR and How swap are same meaning, does it? 2. Among daughter cards, I found on the documentation that DFC ca...