Finding accurate answers to your questions and issues is always gratifying, but what if these answers are shared globally across different languages? The Cisco Community team has been working on a proof of concept (PoC) to take Accepted Solutions in...
I am trying to write a QoS policy that will allow shaping per remote site. The current head-end config is overrunning the remote sites. Here is a sample of the proposed config: !QoS Policyip access-list extended qsi-acl permit ip host x.x.x.x any p...
Hello Cisco experts, I am a community manager for the SNTC French language community and a user has reached out to me with an inquiry on how to configure a VIC2BRI-NT/TE card on a 2800 series Router. Can you point me to the appropriate technical docu...
Hi, Is there a way to block https sites? I want to block torrents, p2p, porn sites, etc on my Cisco ASA 5505 router. I have ASDM 7.3 for ASA. Would appreciate if someone can help me on same Thanks, Sagar
hi, I have a 3900 ISR router. I have accessed to a first time. Right after, we had an electrical cut, the router rebooted suddenly. Right after, I cannot access to it anymore. I have performed password recovery procedure many times after. Without su...
hi sir Please help me to creat internet connection on my cisco router 1841 i configure Ip address on fa0/1 124.124.43.113 255.255.255.252 and fa0/0 192.168.10.1 255.255.255.0 i give ip route 0.0.0.0 0.0.0 124.124.43.114 and i have 2 dns also 202.13...
HiFrom what I understand in the show ip bgp x.x.x.x/x output the received-only would be present when soft-reconfiguration inbound is configured and the route has been rejected by a policy i.e. a route mapWhat i have also found is that on many outputs...
Hello, I need to prioritize Skype/any traffic over other traffic in Cisco ASA 5505. How can i do that. CIR 2/2 Mbps Regards, Nooruddin
Hi, I'm trying to configure a dual wan connection with a ASA 5506X, I have these 2 ISP networks and want to be able to load balance my traffic between then. The two ISP has fixed external IP on my WAN port and I also have and external /30 pool of IP...
Hi Everyone, I have a 800 series router with ADSL/VDSL built in. I am using ADSL2, PPPoA over POTS. The router is dialing and is getting config from my ISP, but it is saying it can't install the default route. The ppp light is lit and if I enable s...
Hello,I have 5 mbps line speed, i want to limit file transfer 1 mbps, (shouldn't pass this speed) and 4 mbps to ERP.How can i do that with qos? Thanks.
Hi. My router recently will not boot from the flash. I keep getting the rommon prompt. When it tries to boot I get:Code:System Bootstrap, Version 12.2(11r)YV6, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisco.com/techsupportCopyright (c) 200...
i have an existing PPP multilink with two T1 circuits in it. we ordered two new T1 circuits (same ISP, and they know to put them into the bundle). all the cards are wic1-t. i copied the configuration from the existing serial interfaces (0 and 1) to t...
Hello all, I would like to get some solution on below. 1. I have a single router which connect to two different provider internet circuit (circuit A and circuit B) 2. WAN facing running BGP 3. LAN facing running eigrp 4. LAN have two public subnet ...
Hi All,I have one "NM-4E1-IMA" card installed on 3725 router. Now I have installed new "VWIC2-2MFT-G703" card in the same router with the latest IOS 12.4T (Which supports this card).Now I have a question regarding terminating the new E1 DATA circuit....
Hello, I have been asked from my ISP to limit our WAN speed to 95% as to aviod policing protocols on thier end which can result in droped packets. Is there a way I can do this for both Download and Upload?
