Routing

I have a cisco 7609 with sup engine 720, I want to implement VPLS for that I purchased a   7600-ES+20G3C    with  the adv license  76-ES+ADVIP-LIC in a separate pakCan you please help me how to activate the license on the 7609.

Hi all as per cisco config example : Load Sharing When Multihomed to Two ISPs Through Multiple Local Routers Load balancing is not possible in a multihomed environment with two ISPs. BGP selects only the single best path to a destination among the ...

I recently got a Cisco Switch 871W - I finally got it configured to my imac, but when I go into it to reset the admin password within the GUI it doesn't reset, and when I go into the terminal - I am not seeing it as it boots up. Does anyone have any ...

Hi, Just saw that udp/161 was open even though we have an ACL on snmp community -WHY IS THAT? SNMP is closed so that i cannot do a snmpwalk, but it's concerning that udp/161 is still open. snmp-server community ********************* RO SNMPACLsnmp-...

Hello all guys , cisco fellows  Kindly , How can i subneting IPV6 thanks 

Hello friends, How does one decide on an image upgrade to a new iOS.  Do people usually go for the newest releases or one with less bugs then another?   When you guys are doing a software upgrade on a switch(whatever platform) what do you factor in...

i need to connect an SG 200 to a Cisco-3560-X and i'm having issues.  I'm kind of a newb but getting a little better.  I think i know enough to be dangerous.  lol  I can't seem to get connected at all with what i have setup already. I have a few VLAN...

Dear Experts, Logs of my 887 get filled with dhcp restart messages every two hours: May 16 15:08:34: %DHCP-5-RESTART: Interface ATM0.1 is being restarted by DHCP.May 16 15:08:44: %DHCP-6-ADDRESS_ASSIGN: Interface ATM0.1 assigned DHCP address xx.xxx.x...

Hi All,    We're getting this error message when we run a 'show environment' command on our 3845 router:SYS PS1 is present.        Fan status: Normal        Input Voltage status: Normal        DC Output Voltage status: Warning - failure        Type: ...

I am trying to connect a NEC DX system to a Cisco IOS router.  The NEC system T1 line is configure with a type of 24 channel CAS.  The config which is specifies is " Direct Inward Dialing (DID) Wink Start (DTMF and Dial Pulse) "What would that be in ...

I recently got a Cisco Switch 871W - I finally got it configured to my imac, but when I go into it to reset the admin password within the GUI it doesn't reset, and when I go into the terminal - I am not seeing it as it boots up. Does anyone have any ...