Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Hi all, I post this to ask "how to redistibute management interface on BGP" basically, when execute "redistibute-route direct" under bgp configuration, managemnet interface ip address is not included on advertisemnet packet. right? if I want to redi...

Ray Han by Level 1
  • 897 Views
  • 4 replies
  • 0 Helpful votes

Dear Experts, I need help on below topic. Working for two data centers. In one data center, total four Nexus 7K's are installed. One Nexus 7K pair function as access/aggregation & another Nexus 7K pair functionn as core switches. In another data cent...

Hello All,For IP Subnet 10.230.126.16 /29 , below routes are seen on a router.ip route 10.230.126.0 255.255.248.0 Vlan201 10.230.201.254ip prefix-list sys-to-innw seq 60 permit 10.230.126.0/21 and there are also more specific ones seen as below:ip ro...

suthomas1 by Level 6
  • 361 Views
  • 1 replies
  • 0 Helpful votes

hi Experts, I have 2 sites which i have connected using fibre and microwave link. but i am unable to configure the failover. Am not good at configuring Cisco routers so i need someone to elaborate to me how to do it step by step. i want that when the...

I am facing issue with ASA  Traffic from Inside towards Outside interface is not working properly. 1. If I ping Lan device to Inside interface of ASA (Locally Connected) I am getting replies. 2. But if I ping LAN device to Outside interface of ASA t...

Hello I have a list of devices that have Smartnet contracts associated but the contract is not linked to my account. Con you link the contract with the devices attached to jmoneta@globalsteering.com

jmoneta by Level 1
  • 656 Views
  • 2 replies
  • 0 Helpful votes

I have a legacy configuration, where my switch is connected to a firewall, via a trunk.   The firewall is showing a lot of overruns. The switch config is: Int f0/7   switchport access 52   switchport trunk native 52   switchtrunk trunk allow vlan 52...

jimmycher by Level 1
  • 1908 Views
  • 3 replies
  • 0 Helpful votes

We have a 3845 (v12.4) that has a frame-relay connection on it's S2/0 interface.   It calls out "priority-queue 1", but there is no frame-relay map class "1". Does this mean everything goes into the "normal" queue, and it is effectively FIFO ?? Tha...

jimmycher by Level 1
  • 783 Views
  • 2 replies
  • 0 Helpful votes

Hello Dears, I am trying to apply redirect Layer 4 traffic  on cisco router asr 1004 by using cisco avpair attribute, the problem is when I receive the av pair attribute from the Radius server I cant connect as PPPOE user, we using free Radius. here...

Hi, I would like to ask if I have 2 block IP address from ISP 1 and ISP 2, then I would like to make 2 inside NAT map to 1 one web server, lets say : 100.0.0.10 (ip ISP 1) and 200.0.0.10 (ip ISP 2) to map to my web server. My question is, lets say I...

I have a 2901 router that I am trying to configure RDP from the outside. Currently, I have a DSL connection coming into the router using Dialer1 to connect. The internal server IP is 192.168.115.2 and right now, I am using the default RDP port 3389. ...