Routing

Hi i need assistance on how to  access the Rommon priv password , as the cookie is corrupted on the Cisco 1841 Router. im unable to calculate what the possible password could be. can anyone assist to help figure out the priv password rommon 1 > cooki...

i got trouble getting a ASA running with failover etc: Scenario ASA is connected - external with two ISPs - internaly with a Transfernetwork with mutliple networks behind (for example: 192.168.0.0/24, 192.168.1.0/24) i got Servers in the Internal Ne...

Yesterday , I have a Cisco Switch 4506E reboot , what does it mean ? cisco4506#sh version Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500-ENTSERVICES-M), Version 12.2(53)SG, RELEASE SOFTWARE (fc3)Technical Support: http://www.cisco.com/...

The problem i'm running into is all the sample configs for this card i'm finding are for much older code, i need it for a 1921 with version 15.2(3)T.Any help is very much appreciated.

Hello all!Everything worked fine untill... I introduced second ISP for redundancy.I have C881 ISR installation with two ISP, both are NAT outside with failover.When both ISP work fine, ISP1 is used to NAT internal users to outside internet and ISP2 i...

the problem is pc0 cant comunicate to pc 1 im using ospf on both routers both pc on same vlan and subnet what should i do? i feel i have to use diffrent ip for the remote pc?

Hi guys, I am trying to find information on applying multiple IP addresses to a routerbasically one for the Router itself and then some for the devices behind the router, Which i am sure I need to apply some 1 to 1 NATs. I just do not know if i need ...

Dear Experts ;                      I  dont have much experience  about  configuring qos . i have to configure wan QOS on the network . i am really confuse from where should i start ? since i have HQ and  5 sites and each site has voice and video end...

I was able to monitor with SNMP, how many channels are used on my PRI. i used cpmDS1ActiveDS0 MIB on my old 2811. I've just changed my pri router for a new ISR4321. I can't find the right MIB for monitoring my PRI channels on the ISR4321. Any idea?

Hi We are migrating our ASA connection from Cisco 6500 to Nexus 7000. Which means i have to copy the 6500-SVI to Nexus-SVI.  There is a ip tcp adjust-mss command configured on 6500-SVI.. my question is what is the equibalent configuration on Nexus7...

dear All, i have come accross this following network scenario and got kind of stuck. The Service Provider is connecting two remote sites of its customer with customer's head office. Requirement of the customer is to provide them Trunk Links to all th...

Hi , I am a newbie working on PPP/PPPoE . I have read the RFC's related to PPPoE/PPP. I understand that PPPoE/PPP runs between CPE and BRAS/BNG edge router. But want to know PPPoE is called as point to point ?