Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Resolved! DMVPN question

Hi community,I need some advise on DMVPN of my customer came at a situation to expand their data center from one to two current set up - existing data center has 2 dmvpn router acting as hub and other offices are connected to...

Jigar Dave by Participant
  • 2 replies
  • 0 Helpful votes

about power a ie-3000-8tc, I don't understand the difference between an PWR-IE3000-AC and (PWR-IE65W-PC-AC= OR PWR-IE65W-PC-DC=).which one should  I use? thanks PD. 22-dic-2014. after 15 days, looks like nobody knows the answer to this question.

Hi Guys,This seems to be a tough one. I am creating a tunnel between cisco 2911 and Yamaha router RTX 810. Its really difficult because i can't find any documentation between yamaha and cisco 29xx series routers.Should i replace the yamaha router wit...

I'm not able to apply a route-map to a VLAN interface on this layer three switch. Switch:WS-C3750G-12S IOS:c3750-ipservicesk9-mz.122-53.SE2 Route Map Config:access-list 151 permit ip host any!route-map TEST permit 10match ip address 151set ...

HelloAfter a router reboot , found this on startup.......Initializing memory for ECC.c2811 platform with 262144 Kbytes of main memoryMain memory is configured to 64 bit mode with ECC enabledReadonly ROMMON initializedopen: file "c2800nm-adventerprise...

Hi I've got two VLANs and 11.0/24Problem is that I wanna watch DVR with address from 1.0/24 VLAN, but I can't ping address on the other VLAN. In this router there are route-map and ACL commands and I will show current co...

Hi All. I forgot to remove the access-class 23 in line from my VTY settings so now I cannot remote access a router. Anyone know a work around for this to hopefully help me save the 12 hour round trip drive to console into the device for 5 minutes?I f...

i am learning advance bgp : having queryBgp stores its database in adj-rib-in, local rib (bgp table) and adj-rib-out...1. but is there any command to show the output of it separately... how can i come to know what is in adj-rib-in or rib-out table ??...

s4sandyad by Beginner
  • 6 replies
  • 0 Helpful votes

Hi,I will be setting up Full Tunnel SSL VPN using my asa 5520 as a vpn server.After reading documents I know that NAT must b disabled on ASA for the pool addresses.Can anyone explain te exact logic behind this.Regards.