Routing

Hi, on a 4mb MPLS link we observe the tx and rx as given below. As per my understanding the transmission and receiving load is utilizing nearly 91% over the available 4 mb link. I have divided the respective values of tx and rx each of them by 255 an...

Hi i have one remote site, i am unable to ping my remote site firewall from my current location packet is dropped at router any one help me to solve this?

Dear all,I would need you suggestion to find a Cisco device which will support this configuration:We need to have to ISP connections on a Cisco device (ASA or Router) - one would serve for Internet, another one for site-to-site VPN (no load balancing...

Recently in attempt to verify symetrical routing at our network edge, I was checking to see what routes were being advertised to our ISP's BGP speaking router.Running the command "sho ip bgp neigh xxx.xxx.xxx.xxx advert" I was greated by a list of ou...

I have to implement QoS on 3750 switch.I have two types of traffic received on that switch.I have two incoming links both of 10Mb. The outgoing link is 10Mb as well. I have high priority and low priority traffic coming to switch that passes through t...

hi  I have issue with bop traffic passing through 3750g. Is there any feature set or sum or platform forwarding I need to enable. eBGP is establish between 2 router connected via 3750g and and I can see the routes exchanged. But when I traceroute the...

How can i make a crosslink by 2 routed ports. The switchport in the router has vlan1 and the routed port cannot ping the vlan1 ip. On the other router i had the same interfaces. How can i add the routed port to the vlan1 ??? So the port should act as...

How Frame-Rely Inverse ARP work ?And what is the use of "frame-relay map ip 10.10.1.11 101 broadcast" brodcast word in this command ?

I have an ASA (configuration attached) with an  inside network (192.168.255.0/24) that I can access over VPN. I have configured the ASA NAT and Access Rules to allow internet access to inside hosts.The inside hosts have static IP. Whenever I change a...

Hello, Looking to support multiple ISP connections.  I would like to build some redundancy for our incoming connections, however, not sure we will be able to utilize BGP.  Is there any other options?  I am trying to figure out how all our incoming co...

Hi Team,Please find the below observations. Kindly help me to find a solution for the load balancing issue that we are facing in Cisco 7600 Series Router. 1. In MPLS Router, there are 5 STM-6 media and normally the traffic is sharing by all media.2. ...

Dear All,We two offices connected by 100 Mbps ethernet link. recently we added one more 100 Mbps ethernet link for load sharing and reducancy. I planned to configure ip cef on the both the routers, ip load-sharing per-packet on interface with proper ...

Got kind of a weird case today when I was about to configure a switch (3560cg, iOS version 15.2(2)E2) for RADIUS authentication on switchports to only grant domain devices access to our network. I already tested this on another 3560cg with the iOS ve...