Routing

All I have 2 sets of server that replicate over a WAN link.  I would like to limit the bandwidth to 10mbs for these servers only. The servers reside on the 10.1.6.0/24 and 10.4.6.0/24 subnets The N7K and the Cisco 6500 both connect directly to the WA...

Hi All,What happen when port fast enable port start receiving BPDU from other end.Is it loose port fast capability and start working as normal port and after listening learning it will block the port. or is it work as a port fast to allow BPDU so tha...

Hello Guys I am trying to redistribute a static route from one CE device into OSPF on another CE device, but it seems to be redistributing all other static routes except for one. It does not seem to be advertised either. I have checked the associated...

Hi all,I have some problems involved Cisco Catalyst 2960 Switch.I am using a device which includes Marvell PHY chip 88E1111. The device can send and receive PTP packet to and from my PC.Now, I want to connect the device and the PC to Cisco Catalyst 2...

Hi All, First of all apologies as I am new to Cisco.I have 2 sites Main site routers 1 is configured for internet having IP address 10.10.10.48. 2nd router is configured for VPN on separate data link configured with bgp protocol having ip address 10....

Hi all Is it possible to extend a vlan between 2 sites using routers, via serial, Ethernet or frame relay, its none mpls so eompls is not possible cheers Carl

I am getting the below error when I try to TFTP to a server in our domain. Any ideas. I checked the permissions on the target directory and it is good, in fact I opened it wide open to test and get the same error. I can TFTP to my laptop fine. The se...

Hi, I need to upgrade the rom monitor of a 2921 ISR G2 from currently installed 15.0(1r)M15 to the latest one 15.0(1r)M16. The upgrade command is running without any problems: # upgrade rom-monitor file tftp://10.10.10.1/C1900_2900_RM2.srec.SPA.150-1...

Hi all,   I have a Catalyst 6500 with SUP720-3B whith 1GB memory (MEM-Sup720-SP-1GB=  and MEM-MSFC3-1GB=) which is going to receive full BGP table, I know about the limitation of 256K routes of SUP720-3B, but with the following memory will it be able...

Dear Team there are 4 interfaces in our router(L3), 0/0/00/0/10/0/20/0/3 first three interfaces (0/0/0,0/0/1,0/0/2) are connected to ISP fourth interface(0/0/3) is connected to local network  my question is that when i ping to certain sites or ip's f...

Hi, I have a computer in my office network with ip address 192.168.1.10 and i have one public ip 175.101.6.69. I want to assign this public ip to the internal computer so that traffic shoud go to outside using the public ip 175.101.6.69.. How to conf...