Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Don't miss this Cisco Catalyst 8000 offer

 
Labels

Forum Posts

Probably a simple question, but my BGP skills are next to nothing....apologies in advance.Scenario:CompanyABC owns a /22 subnet of 1.1.0.0.  The full /22 is advertised out of CorpOffice1 to ISP1.  There is a route-map configured that uses a prefix-li...

I am getting below error in new 7606 installed in our network.%DEV_SELENE-DFC2-3-SRAM_ECC: Selene 0 SRAM High Single-bit ECC error, error status: 0x400182505 I am unable to find exact reason for this error over internet.Someone, please help me get de...

I want to configure EVPL circuits, so that each EVC (sub-interface) is traffic shaped to its CIR.E.g. If I have four EVCs to four different sites on a 1Gbps UNI, vlan 100 with CIR 100Mbps, vlan 200 with CIR 10Mbps, vlan 201 with CIR 10Mbps, and vlan ...

Hi,I have one 1941 Router which is connected to internet and its having 1 public ip address x.x.x.x and i have 2 devices having 1.1.1.1:90 & 1.1.1.2:91 which are configured with private ip address and port numbers.  I want to translate to these devic...

We recently installed a 100Meg MPLS fiber ring into our office, and we were given redundant connections (north loop and south loop). The North loop is the primary interface, and will be used unless the fiber is cut. I need to configure our router to ...

Hi,I have Cisco 1941 Router and it has 1 public ip address x.x.x.x and internally we have 2 devices having 1.1.1.1:90 & 1.1.1.2:91  private IP addresses and i want to translate from outside to these 2 devices. example:  x.x.x.x:90 and x.x.x.x:91 How ...

I am wanting to apply QOS onto some of our WAN circuits.   Here is my scenario.   Headquarters end has a 45Mb DS3 to the MPLS cloud.  Remote end has a multilink T1 (3Mb) connection to the MPLS cloud.   We are doing BGP to the cloud itself.     My pro...

jonesl1 by Level 1
  • 317 Views
  • 4 replies
  • 0 Helpful votes

Hello, I'm configuring a  CISCO1921 router as a teminal server at the moment.I used http://routing-bits.com/2008/09/30/cisco-terminal-server-with-menu-command/as a config template and it works.I just added ssh to access the router instead of Telnet. ...

Hi,I need that incoming connection to port 3389 come to ISP1, and incoming connection to port 5800 come to ISP2. I configured the follow config, but not working, could you help me?And i need another config, the IP SLA to configure outbound traffic fr...

Hi Apologies in advance for my lack of knowledge on this subject, I have a cisco ASA 5505 running software version 8.0 (2)I am attempting to gain a WAN connection for clients on the LAN behind the ASA, the ASA will sit behind the primary router and a...

I am wondering if someone can give me a quick answer to this. I recently upgraded our catalyst from IOS 12.x to 15.2. I noticed that there are some config items that went missing in the upgrade. I am guessing they are depreciated, or unnecessary (as ...

J W by Level 1
  • 566 Views
  • 6 replies
  • 0 Helpful votes