Routing

Hi everyone,I want to start by saying that I brought a Cisco 2811 Router to use at home and to practice advanced networking with. So far, I believe I've configured everything as it should be, however, I am not getting any internet connection.DHCP is ...

New to Cisco and need some assistance, any help is much appreciatedWhat I want to happen is fastethernet0/0/1 to be primary for all internal request, web browsing, youtube etc. then if it is disconnected then fastthernet0/0/0 will take over as primar...

I configured my CISCO887VA-K9 but after the reload, no configuration is in the router. I tried to configured only the hostname but the issue persists. Router(config)#hostname PRUEBAPRUEBA(config)#PRUEBA#wr *Oct  1 09:18:09.212: %SYS-5-CONFIG_I: Confi...

I Keep Getting this Error on Router 1 and 3 ?? "DUAL-6-NBRINFO: EIGRP-IPv4 blocked: not on common subnet" Any Ideas ? I am still able to ping though all routers and pc's?  Router 1 config hostname R1!boot-start-markerboot-end-marker!!!no aaa new-mode...

We've recently upgraded a WAN link to a DS3.  Encapsulation is Frame-Relay.The link is an MPLS link, with a 2MB guaranteed delivery ("GoldCAR") rate.We're seeing utilization on the link up to 20Mbps, yet we're also seeing tail drops.  We want to matc...

Hi,I'm trying to setup QoS policing to limit bandwith for some protocols. I'm using a 881 router.I just want to police the traffic for the protocols and configured this: class-map filetransfer match protocol itunes match protocol bittorrent match pro...

Attached is a network diagram.I want to setup OSPF throughout and also advertise a default route. The ISP that provides private MPLS runs BGP and will redistribute all OSPF routes to the PE routers (PE1, PE2, PE3, and PE4). I cannot configure the PE ...

Dears,I need helping for designing disaster recovery between two sites. The customer want 2 cisco catalyst 6500 series switch as core devices at each sites.designing physical and logical connection between two 6500 swiches at each sites?(solution1)de...

Hi Friends,Imagine the simple scenario, with interface inside to lan address, and two ISP links. I would like to know, if is possible, the follow situations, and please could you send the examples and articles explain how to do this, using router Cis...

using the Cisco VPN Client dialer. Able to connect to the VPN but unable to access network resources. Suspect I do not have the necessary ACL. Any help is greatly appreciated!Building configuration...WLAN_AP_SM: Config command is not supportedCurrent...

Hi everybody,do 888 and 887  routers (specifically CISCO888-SEC-K9 and C887VA-V-K9) support LACP as Catalyst do ? What I need is to associated a couple of interface of the integrated switching module to a channel-group in LACP passive mode and config...

Hi everyone, I have  a problem with llq policy and a cisco 888EA router. In my test lab, i have an interface vlan1 which connect lan. Second interface is a vlan 3 and simulate a wan connection.From my linux laptop i send 20Mbit/s of udp trafic, and a...