Routing

Hi, Could anyone please go over my config example for a check. I believe I've configured a bandwidth restriction for host xx.xx.xx.xx to have a Internet bandwidth restriction of 50Mbps from 8am to 6pm and a Internet bandwidth restriction of 75Mbps fr...

Hi Team, We had Cisco 2951 Router installed at the Customer site and reported hang issue. Then taken show tech for this Router to check the exact cause, the IOS impact or any Hardware related indication with logs. Running image details as below, D...

Hi, I am trying to implement IPv6 ACL on Cisco 6500.Any suggestion for the example of the good IPv6 ACL for 6500 would be appreciated. Thank you Salja

Hello  I have the following issue with a Cisco 2811 router. I have two WAN connection ( fiber and ADSL ) and I want to make WAN load balancingso I add two route : 0.0.0.0 0.0.0.0 dialer1 and 0.0.0.0 0.0.0.0 fa1 the problem is with fiber connection (f...

Hi everybody !As far as I know the purpose of combining the two, shaping and CBWFQ, is because the latter requires congestion to engage, the former can create congestion sooner than the physical interface.My question is, when the congestion from the ...

Hi,I need help and clarification regarding the software license of Sup 7-E and Sup 8-E. Based on the catalog  it ships with IOS XE universal image? Here are my inquiries.1. With IOS XE universal image, what is the software license installed in Sup 7-...

Hi,Is it possible to activate nat harpin to activate nat hairpin so that internal user can access to an internal server by rdp with the WAN IP adress ?By default the typical configuration isint fa 4description wanip addresse X.X.X.Xip nat enabletrans...

I have 50 GRE tunnels setup on one router that goes out to 50 remote sites.  One site has two tunnels, one for primary and one for backup.  The backup tunnel is not coming up.  The access-list is incrementing but the show crypto isamp sa says mm_no_s...

We have a server in our network that has to be accessed from a public IP address.We have set up the nat statements on the router but we are unable to connect using the IP address and port number. I did  "show control-plane host open-ports" and it doe...

Hi all,Regularly getting the following error appear in my logs and looking for some suggestions: %MV64340_ETHERNET-5-TOOBIG:  GigabitEthernet0/0, Tx pak is too big, 2998 bytes So, interface G0/0 is configured as a 'Trunk' and the default MTU is set.A...

How many OSPF neighbors ME3600X supports?

My client is using an 891 ISR - can I configure the WAN port to allow me to have remote access to the router for troubleshooting and montioring? What syntax would I use to configure this?