Routing

Good afternoon,I'm hoping someone may have had same issue or may have a fix for a weird issue I am having with My ISA550.I have recently updated the firmware on our ISA550W to 1.2.19 and it seems ever since then any connection to a https site takes a...

Hi ,I have a 100 mbps leased line from ISP1 and 50 mbps from  ISP 2 between two offices .That means A and B location of both the leased lines are same.My question is it possible to Linkaggregate or multipoint (multi link ppp) these lines for a total ...

Hello,We currently have two ISPs for our internet connectivity and we are load sharing traffic between the two. Currently we have static routing with these ISPs. Our plan is to change that and implement BGP multihoming with the two ISPs. Also current...

Hi all Im looking into creating a standard 4 band qos model for all my wan routers they would bePlatinum - voicegold - videosilver - sap / lotus notesbronze - best effort There is a 10meg interface on the router.2 meg priority for voice3 meg at least...

Hi all I have 2 sites, with 2 links between both sites, the links terminate on separate routers. One link is 64mbit and the other is 18Mbiteach router on the site is on the same subnet. I would like to load balance across the links if possible, un eq...

Hello all, So quick background, I work for a company that buys and sells IT equipment, a lot of cisco. Typically we're dealing with 1-5k pieces of equipment and our proceedure is to do basic testing such as test ports, if it PoE - make sure those wor...

I am configuring site to site between fortigate and asa. I am not sure if I am making any mistake in configuration or not. I got information for fortigate and based on that I am implementing peer config in asa. Below is my config. : Saved:ASA Version...

Hey folks,We are converting our offices from MPLS to VPN Site2Site tunnels.the tunnels are all operating properly with all traffic going in both directions.Our issue is with Traceroute between sites.On MPLS, everything replies during a traceroute. Be...

Hi everyone, We have a few sites all interconnected through VPLS and are coming around to realizing our current OSPF network type is not the best choice. Because it is an Ethernet handoff, the default OSPF network type is Broadcast which in this case...

Hi All, I have a webserver in my network with IP - 192.168.10.5 and i have done static NAT with an public IP (ex: 10.10.10.3) in my router to access this server from outside networks. We can able to access this server from other networks with this Pu...

I have Cisco 3750, 2960 and 2960-s. I configured vlan in 3750 and trunk it to 2960 and 2960-s. The 2960 is working fine, However 2960-s  not able to learn any vlan. If use switchport mode access it able to connect to vlan1. But if i use switchport ac...

Hi, My colleague and i are struggling to originate a IPv6 BGP default route from one of our core switches to an eBGP peer. This is the configuration (below) we have tried and does work within GNS3 running the same IOS but it doesn't seem to work on o...