Routing

Hi all,I have scenario I connected my Cisco 2960x-24Gig switch with a server hace 1000BaseT NIC and configure a  switch port as a trunk with on mode...trunk is working but the  trunking is  at a-100 speed i didnt assign any any manual speed on either...

Hi all,When i'm trying to ping any public IP e.g 4.2.2.2, 98.138.253.109(yahoo.com) without putting any source it is working fine. As you can see below OCSRTR#OCSRTR#ping 4.2.2.2Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 4.2.2.2,...

Here's the 3825 log sesstionplease help me for find problem!after crash , i have upgrade the rommon because the old rommon cannot read flash in rommon modebut when i upgrade the rommon to the newest versionit was also can not read flashand i upgrade ...

I am interested and only allow SSH traffic from entering from a lan interface and not my outside public facing interface.  I am noticiing random user accounts with the show users account.  I see the ip address that it comes from.  they only show bein...

If RSVP and MPLS TE doesnt actually reserve any bandwidth in hardware(i.e data plane) of the box and doesnt do any qos.  Then what happens if TE with reserved bandwidth of 50 mbps is sending out of data at rate of 100 mbps, and their is another TE tr...

We have used many Point-to-Point T1's in the past, where one end was bonded in a DS3.  I am setting up 2 T1's right now that are truely point-to-point.  They are working, but I have a question.  I'm not sure if I have my clock set up correctly.  Here...

Hi,I was wondering, if I get the PoE switch module for a 2951, will I need a different image than c2951-universalk9-mz.SPA.151-4.M2.bin to be able to configure and use it?  Also, is the 4G WAN module backwards compatable with 3G?More sh ver output fr...

I have had QOS on some older routers and switches with the following commands class-map match-all VOIP-SIGNALINGmatch dscp af41class-map match-all VOIP-RTPmatch dscp ef policy-map VOIPclass VOIP-RTPpriority percent 15class VOIP-SIGNALINGbandwith perc...

Looking at CISCO 2900 series data sheet, there is a sentence under "Benifits"The Cisco 2900 Series enables deployment in high speed WAN environments with concurrent services enabled up to 75 MbpsCan someone please explain what does this mean? The int...

Hi,I am trying to create a Router On a Stick (two interfaces on a single NIC): eth0 not tagged and mywan@eth0 on vlan id 2. The interface "mywan" seems to be tagged.2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP mode DE...

Hello,I started to work in a network where there are a lot of cisco 861 and the routing protocol its Ripv2.We are having a big problem with the time convergion because we use 2 internet network providers that usually have problems and waiting 90 seco...

I am having no success locating win7 driver for USB console session for newer  3850/2960 lan switches.  Where can I find the driver?  Thanks!!

Just rewiring my routing brain after several years of a domain change(born again newbie alert)...but wanted to understand some pointers here Can we use the CSR1000v vNIC0 (which gets placed in a management VRF by default as its off a IOS XE codebase...