Showing results for 
Search instead for 
Did you mean: 


Forum Posts

        Hello,I am having a problem with my failover design.  I have a remote site with an MPLS connection with BGP between the PE and CE routers.  On the remote site I am running HSRP between the two routers, however there is no direct connection be...

Hi,I have a module of HWIC-4ESW installed into Cisco 2811 router where 3 WAN link is terminited. Suddently WAN links stopped working from last night. I have performed shutdown and no shutdown in the interface but still the the WAN link was not workin...

rumi_2k by Beginner
  • 4 replies
  • 0 Helpful votes

I am having one question regarding conditional default route advertisement in rip.    My SETUP============= R routing tableC      ...

Hi,I am running ospf in hub and spoke scenario all frame maps are active and can ping each other, now problem is can’t see any ospf neighbor relations with other routers all three routers are in same subnet and in same area and also checked the hello...

feroz syed by Participant
  • 12 replies
  • 0 Helpful votes

Dear AllI have internet router (IR-1) connected to Core switch and three ISPs this router is very old, my plan is bring new internet router (IR-2) and do following steps for shifting the traffic :1.       Enable IBGP between IR-1 and IR-2.2.       Sh...

Steev112 by Beginner
  • 3 replies
  • 0 Helpful votes

Hi,reading CCO documentation for OER it is not so clear to me the difference between backoff timer (3 values used for dampening) anf holddown timerBTW which are the triggers for OER to evaluate the MTCs and in turn move them to another exit link (if ...

HiCan you help?I am trying to find on Cisco's web site the specification of their power cables for the ASR1002.  I am particularly interested in the NEMA specification for  the US power cable CAB-AC-RA .Phil

pbelletty by Beginner
  • 2 replies
  • 0 Helpful votes

Hello,I would like to ask for your help with choosing a switch for my network.What I have:-Office #1. 25 users (PCs + VoIP phones) with Cisco ASA which does QoS and security-Cisco 1841 Router-50Mbps internet connection (supplied over ethernet cable)-...

Hi all,I am facing issue with using IP SLA, i am given a project in office and need to implement policy based routing,for some reasons i want to use loopback for it.I have 2 routers A and Bi just want if traffic from 216.0 network comes on A set next...

Branch office has 881 VPN router. Services that ignore MSS in packets don't work. Adjusting MSS has no effect since the services are ignoring that setting. Example: works fine, but some Yahoo sites don't.Found a workaround for exceeded...