Routing

Hi guys,I am using 3548 to connect to partners.I use a VRF, with static routes, and my VRF can ping hosts behind the next hop. Perfect.In my VRF, I can get routes from the default VRF :[...]vrf context myPartner  address-family ipv4 unicast    import...

Hi,I am trying to get OTV up and running through VRF between 2 sites but it seems that the OTV-isis is not forming an adjacency. There is a dark fiber between the sites so no SP interference.2013 Sep 30 14:37:38.418027 isis_otv default [30596]: (Over...

Hello everybody,I've connected two Sites by xconnect through internet with ASAs IPVPN We have equal configuration on both sides like this:SiteA:---------------------Switch Cat4500:---------------------interface GigabitEthernet2/2/45 description Route...

Hi,Please let me know what are the attributes available for BGP to influence outbound and inbound routing. And which are cisco proprietary attributes.Thanks in advance,Naveen

Buenos Días.Tengo un servidor samba en un sitio remoto, y desde mi red no puedo acceder. Es problema de mi router cisco, que bloquea el trafico. Tengo una acl: access-list 100 permit tcp any any 445, para que permita el trafico entrante del protocolo...

Hello All,I am trying to create a policy map, that will match all my SAN replication traffic and limit that traffiic on the interface to 80 Mb/sec.          1. I have created the ACL.       ip access-list extended Gue-SAN-Traffic      permit ip 172.2...

I am looking at using the ASR1001 as a BGP internet router but also require MPLS LDP - I do not necssarily need to terminate MPLS Layer 3 and Layer 2 VPNs (although this would be useful), but do need these services to traverse across a couple of ASR ...

Hi Guys I need some help with my config, it was working without the L2TP setting, if I change my default route to the virtual-ppp1 I can still ping to the outside but cannot browse at all, everything times out.my config:no service padservice timestam...

Once the DR and BDR have been elected, the other routers (known as DRothers) will establishadjacencies with the DR and BDR only. All routers continue to multicast Hellos to the AllSPFRoutersaddress 224.0.0.5 so that they can track neighbors, but DRot...

Hi,I have tried MED with ROUTE REFLECTOR in one lab,but it is not working !!!!! here is pictureMy problem is I have loopbacks on R1 and want to give MED 70 on R2 and R3 30 .....so that all routers outside R100,R200 etc etc... choose R3 to reach R1 lo...