Routing

I'm looking to boot one of two images available on internal flash of a 1921 router.  Currently 151-1.T1.bin is being loaded at boot.Router#sho ver | in System imageSystem image file is "usbflash0:c1900-universalk9-mz.SPA.151-1.T1.bin Router#dirDirect...

Hey guys,One of my internet routers is showing MPLS packets in the trace.  Is this normal for a pure internet circuit?  CenturyLinkNET#trace 4.2.2.2Type escape sequence to abort.Tracing the route to 4.2.2.2  1 67.63.224.29 [AS 22561] 0 msec 0 msec 0 ...

HelloWe have a Cisco 2911 Router which has different VRF's setup and Route Maps to choose the next hop ip address depending on which VRF we want to use.Anyway, it works perfectly when using a single L3 link between the Router (Gi0/0) and the Switch. ...

Hi Everyone The company I work for has just moved some users to a new remote site, and with it the Cisco 870 router, It has been several years since I have programmed a Cisco router I am look for some help.I just need to change the ADSL credentials t...

Hello,I 've got a cisco 2800 router with two connections to the internet. I use load balancing and I would like tomake a VPN Tunnel to a DMVPN HUB. The issue is that I only can use von Tunnel source.Now my Question is it possible to make a virtual in...

Dear Friends,We have set below policy as below:Policy Map xxxxxxx    Class class-default     police cir 4354000000 bc 136062500       conform-action transmit       exceed-action dropbc value is auto and our customer cant reach more that 4330 Mbps, if...

Hi All,We have 15 subnets on my Lan side, and the inter subnet routing is done by UTM firewall for now, because of which we are unable to utilize the UTM performnace.So we have decided to have a router in between Lan and the UTM to handle that inters...

Hi,i have a 2 cisco routers connected over vpn, Site A (the office) and Site B (remote site)the sites are able to connect to eachother but the router on the remote site cannot ping anything in the office. even though the computers in Site B can conne...

Hi Guys, Im having a weird issue with ssh from a cisco 1941 to a cisco 1941, it used to work fine, but now it hangs...we have two routers at each site, one primary with an EOC connection to the network, and the other a backup 3G wireless connection t...

In the CCW tool I see that smartnet is avaiable for the Chassis but I do not see it for the blades.Is that correct?Thank youNancy

On my 3560 I was setting up an access list and transport to be used for my VTY lines. Previous owner of switch only had vty 5 15 shown in the config. VTY 0 4 was not in the config. So I set up an access list and transport on 5 15. I noticed that I co...