Routing

When I attempt to tftp an IOS image larger than 8MB, I get a message stating I don't have enough space. The flash was recently upgraded from 8MB to 32MB and the router has 128MB of DRAM (See attached show version).Router#dirDirectory of flash:/No fil...

Hi all, I'm having massive problems trying to connect a cisco 876 to my home internet, i've searched google for days and been trying many different configs, I'm really stuck now as i'm still doing my ICND1 and have very little experience with Cisco r...

Good Morning All,I have just been given the responsibility of managing our adsl routers. I have a user complaining of speed issues, I have generated the output below. It states that I should have 8064mbps download rate? So I presume that their downlo...

Can someone help me understand what configuration I will need to connect the new branch office?We have a main office connected with 4 branch offices on dedicated circuits.  The new office is not on a dedicated circuit but instead connected through a ...

I have a 7206X hosting a few vlans to different customers, the 7206X is connecting to a 7609 via another Vlan. I need to migrate all the Vlans from 7206X to the 7609 in order to decommission the 7206X. Not sure how to start and what steps to keep in ...

       Hi there,   we have cisco 3845 router connect to 2920 router via GRE tunnel.  now the size in 3845 is 1500 bytes while 17904 in 2900 serial router. is any command available to reduce the MTU size to 1500 in 2921 router?  Show Tunnel in 2921 ro...

In the above topology how can we tune the path with condition that, from R1:- 192.168.10.0 network is reachable only through 10.1.1.6 and 4.4.4.1 network only through 10.1.1.2 ? All the links are in ospf area 0.

This is the current scenario.Then we got another pool of ip from same isp(2.2.2.0/28).how i will nat by using this new public ip pool in firewall.Pls provide the solution.

====================================================================R2  ------------------CORE----------------------R6f0/0                                                            f0/0  155.1.23.2                                            155.1.14...

I have a ASA 5505 and couple 2950s, they were setup as diasy chain without any redundency in place.I would like to migrate them to a better design. I am thinking each 2950 will have one leg on the ASA, etherchannel (2x) between the pair of the switch...

Hello ExpertsI need great help from all of you , i have MPLS network and running multicast . we have a new integration with Cisco IPTV , scinario will be the headend will convert the signal into Channels multicast IPs over MPLS. We have SSM multicast...

Hola comunidad, les comento un poco la historia:Tenemos dos sedes distantes una de ellas la que llamáremos principal tiene conexión a internet y esta conectada a la sede Distante por un E1 ambas sedes tienen un fortigate como firewall y entre ellas s...

I have a DDR2200 just installed by Centurylink for a bonded pair DSL. It feeds my home network through a Netgear JGS524 Gigabit switch. The DDR2200 locks up at random times. A Centurylink tech told me that the switch was causing the 2200 to lock up. ...