Routing

Hi Guys,I would like a help regarding to  IP addresses in our Core Router (Cisco 2911), see the diagram attached.Currently, we are doing a migration plan of our data center, that's new diagram, but we faced out a problem to set the IP addressES. We h...

Hello,Please note firstly this isn't the way I want/would/would like to do this, simply just what we have inherited and are being told to do by the powers at be. We have two Cisco ASA's 5510/5505. We have a leased line which terminates at a BT NTE Bo...

Hi All,I'm going to try and keep this really brief, so I've done a short version of the question and a long version! Short Version:Should a traceroute (that involves a route being learned through OSPF) through a HSRP pair show both router 1 and route...

My edge router is pegged at 80% and interrupts at 8%.  None of the processes show up as being high.  What is the next step to troubleshoot this?  How do I find out what is using all this CPU?  below is the show proc cpu sort command.  and show proc c...

Hi,I have a query regarding the ping with larger packet size using -l in Windows based systems.When i ping my remote site devices using normal ping the response is ok .The pipe between the two sites is 1G .Same is ok for a packet size of 10000 bytes ...

Will like to share that am able to traceroute with specfic IP but cant ping is there any bug in router. There is no access list levied on any destined or originated host.In below post am able to reach the destined router even that router able to reac...

Hi everyone,I have a routing objective that I am having trouble wrapping my head around.  I have two offices with redundant 1 gig point to points in between.  EIGRP manages the paths.  Baton Rouge which is where my internet connection is located and ...

Hisee attachedWe have three sites that are connected in a triangle for redundancy and optimal routing. At present, all three sites are connected using point to point links and routers are using OSPF as the routing protocol beteen the sites. OSPF cost...

Our project was to change a branch network from a common OSPF area (area 2) to branch specific areas. We made all of the necessary head end changes on our ASR platform and then to the primary 3945 WAN router at the first branch. We successfully estab...

How do you filter a connected interface from EIGRP even though it is defined on the network command?Example:interface vlan 100ip address 10.1.1.1 255.255.255.0router eigrp 1passive-interface defaultnetwork 10.0.0.0 0.255.255.255How do I filter 10.1.1...

Hi,Does anyone know if it's possible to influence only a portion of the networks updates been sent over eBGP connection?If I am advertising the network 100.1.1.0/24, and I have this network directly connected on one interface, the router is connected...

For about 6 months we've had a 2811 with Version 15.1(4)M1 with a T1 card.  No errors on the line.  Then we swapped to a 2911 running 15.2(4)M3.  We took the existing T1 card from the 2811 and just moved it into the 2911.  After the 2911 swap we star...

Hi All,I have a doubt, we need to include a new Nx5K but i would like to pre-provisioned configuration for not disrupt and renegotiate VPCs with another.The problem is that I have  N2K-C2248TP model and this hardware is not support....Could it be val...