Routing

Dear All,we have 2800 router with two fast ethernet and one BRI interfacees..Is it possible to configure tthe BGP with current hardware or do we have to install one more fast ethernet?Pls helpRegards,Vishal

                                  Hi, I am planning a Nexus 5k upgrade (5548) and plan to move from our current NX_OS n5000-uk9.5.0.3.N2.1to 5.2.1.N1.3. There is an alternate option of 5.1(3)N2(1c). Is there any reason why I should choose one of the...

Hi,    I read vtp authentication is supported on vtp version3 only. But when I have version2 configured on all switches and if there is a password mismatch, why the updates are not getting propagated? Version2 should ignore the password,right?Thanks,...

hi i got problem with my upload very slow.when i check in speedtest.net download 10mb upload .10mb , when i remove the router and connect direct to computer. upload and downloads is fast 10mb for download and 6mb upload.router 2821.my config:Code:Bui...

Hi,I have configured an EHWIC-VA-DSL-B for VDSL over ISDN (Deutsche Telekom).The  DSL connection is Annex B and has been delivered by the Telco together with a DSL splitterand an ISDN NTBA (which i want to connect to a PBX).The EHWIC-VA-DSL-B doesn´t...

Dear All,We are using two ISP lines, but we dont have BGP router... Is there any way thatwe can use these lines as failover for eac other??Thanks,Vishal

We have two core switches in our network.In one of them,we have assigned 2 ports to a same Vlan and each of the port is connected to two firewalls i.e firewall 1 and firewall 2.Firewall 1 and firewall 2 further connects to Router 1 and Router 2 respe...

With layer 3 switches now running in the Tbps speed, 10Gb ports,  and supporting BGP.   Is it okay to collpase all layers including WAN into a pair of these switches for a small data center-wan/core/aggregation/access.   The WAN would sit on its own ...

                   HelloI can't see any documentation to say an 887 will support layer 3 etherchannel configurations over two of it's fixed interfaces. Can I confirm this is standard, at this stage. This is a new deployment, so the latest hw version ...

hi,We have several remote sites that we converting from frame relay to point-to-point (leased line) and the telco guys will be providing E1 lines for them. We want to have several sites bundled onto sinlge E1 lines, eg have 3 or 4 sites on a 2Mbps E1...

I have created two tunnels between 2 remote location:one of them working pretty well but not the other:here are the logs:Jul  5 05:49:47.844: ISAKMP:(0): retransmitting phase 1 MM_NO_STATE...Jul  5 05:49:47.844: ISAKMP (0): incrementing error counter...

Gents,My crc errors are steadily increasing on the Ethernet segment, but when i ping the BGP neighbor (so packets travel accross this "bad" segment) i do not see any packets going bad. Anyone got an explanation for this?How is this possible, i would ...