Routing

Hi all,Have a new 6509-E router with 2 sup2T blades. However it came with IPbase and we need to put Ipservices on it. I have copied ipservices IOS to bootdisk and slavebootdisk.However I cannot get get to the boot command to point to bootdisk. It onl...

        I have three routers connected to a private circuit and routing via EIGRP.  The routers are physically located in California, California, and Minnesota.  The problem is, when I do a show ip route, I get:    D EX    10.246.174.0/24            ...

Hi FriendsI am trying to setup multicast over GRE tunnels between a pair of Hub routers to a spoke router. These are connected over an MPLS network that does not support multicast. The requirement is to have unicast work normally via MPLS and use CE ...

Hello,i have 2 sup32's that i just upgraded the IOS on. they were both stable, 1 being active and the other being hot. I then write erase(d) the ios on the sup1 and rebooted. now the sup1 is up but sup2 is in an unknown state. i consoled into the sup...

HiI have this small ISP network.It`s devided into several VLANs, including a separate management VLAN.This has worked quite well.But I see the need to migrate to a routed design now when the network is getting bigger.I still have the need to have a s...

Hi all,i am trying to configure reditribution on my MPLS router , OSPF as IGP redistrbuted into BGP and the BGP routes coming from ISP ip 172.16.16.2 into ospf. i configured the redistrbution for testing purpose its working up to some extent but when...

Hi All,We have a Cisco 1760 router .We are facing sevier packet drops in the serial interface.When i swap the router with another router link is working working fine.Troubleshooting steps taken        1.       Swap the serial cable with another worki...

Hi everyone,I'd like to setup my layer 3 switch ad a router switch with multivlan routing. I've researched the cisco site and it tells me that I onky jave to enable ip routing.My question is I've enabled ip routing but how do you assign gateways for ...

hi there, y have a lttle problem to cofigure a ADSL2+ Conexion in an 1941 router.line protocol are up but didn't have ip adresse in my interface...Current configuration : 1986 bytes!! Last configuration change at 22:32:07 UTC Fri Jan 25 2013version 1...

Im having an issue with the cisco 1760 router, every time the ip address from the A&TT change. I need restart the adsl Wic for it to be able to get another ip address. here is my config, any sugestion will be appreciate. =============================...

Hi all!We have recently deployed several Ciso 887VAW (IOS 15.1(4)M4) to customer premises and I have come to realise counters show extremely high (not at all accurate) output rate and packets on all of them. Any information as to why this might be?Th...

I have an 1841 between my firewall and the ISP.  Three interfaces - multilink to ISP, FA to my firewall, and FA to my inside network.  I use the inside interface for configs aand snmp access, etc.   Only my ISP-assigned fixed address block will get r...

                 when configuring BDI on router, and assigning several ports in the same service instance, will a CAM table be built for each service instance? if not, I guess the ethernet frames will be flooded to all ports in the same service insta...