Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Dear Forum Members, please could you offer some assistance with an issue I have.We have had to replace a Cisco 877 with a Cisco 877VA (DSL & VDSL). Router connects using its DSL interface to the ISP and works ok, from the router if I ping for...

camplingm by Beginner
  • 2 replies
  • 0 Helpful votes

Hello Colleagues,I set up a scenario for the GNS studies, I have problem when trying to close a sessionwith another BGP peer that is not directly connected to the Router. The protocol used toreach and Peer OSPF, Ja realized ping test between these ro...

Hi,I know Pim Dense should be the easiest thing to do but I am having a problem.My network is like this  3925 ring connected by G703 E1 and GigE ints2911 spurs connected to the ring also G703ip multicast-routing enabled on every routerip pim dense-mo...

I want to take my TSHOOT exam shortly.Can anyone recommend any cheap equipment I should use to practice on.Regardsp.s. I have 3 2600s, 2 L3 switches, and 2 L2 switches.

Hi Guys,I couldnt help but notice that the #show frame-relay command doesn't show the layer 3 addresses that the DLCI is used to reach for pont-to-point interfaces.Like for example your :R4#sh frame-relay mapSerial0/0.401 (up): point-to-point dlci, d...

Hi ExpertsPls have a look to the attached diagrami could not able to acheive  load sharing on links running ospf between r1 , r2 , r3 , r4 from the subnet towards the Internet the traffic only use r3 r1 link to go to the Internet r4 ...

Ibrahim Jamil by Frequent Contributor
  • 10 replies
  • 0 Helpful votes

Hello,recently we replaced Cisco 2821 ISR w/Etherswitch module with Cisco 2921 and Cisco Catalyst 3560-X.In previous configuration on Cisco 2821 ISR w/Etherswitch I had the following config to limit traffic to 2 Mbps:!policy-map 2Mbpsclass class-defa...

HelloIf  service provider is providing FR servicesNow for each DLCI there is one CIR, Bc (commited burst) and Be (excess burst)…1-How do they configure these parameters in FR switches? Do they make traffic policing in the entry to FR cloud ? or shapi...

ohassairi by Contributor
  • 4 replies
  • 0 Helpful votes

Hi, I have a few ASA5505 with 50 user licenses, I am wondering if there is a way to use SNMP to keep an eye on the inside hosts to make sure we dont get too close to the 50 user limit.I plan to add it to our Nagios setup.Thanks

jay_oasis by Beginner
  • 3 replies
  • 0 Helpful votes

estimados,     necesito migrar un router desde un 1710 a un isr 3925, desde un ios 122-13.T1 a un 15.1 pero no hay caso, tengo servidores apache publicados y funcionando, pero con el 3925 se caen las publicaciones transcurridos 20 min... el 1710 pres...

m.sonnlef by Beginner
  • 0 replies
  • 0 Helpful votes

Hi all,I'm replacing an 877W router with an C887VA-W-A-K9.The new router uses the service module for managing the AP independantly - So I know I can't simply paste the config accross from the old one.The current router is connected to an ISP with a V...

jdyason by Beginner
  • 1 replies
  • 0 Helpful votes