Routing

Hi,I have tried Cisco presales but got bounced - go Cisco !So, i have a small customer who requires a single device which will provide .....1/ Leased Line connection @ 10mb2/ ADSL failover onbox (so configurable from CLI, unlike the 860’s which I see...

Hi, I have one WS-C3560-48PS-S with a 10/100/1000BaseTX SFP module, and a WS-C2960S-24TS-L with a 1000BaseLX SFP module... Are these compatible for trunking?

Hi, I almost have it all working but.. not quite.I have set up a guest vlan in our office.. we are routing it out to the internet through our data center. I think that is actuall working.Here is the topologyGuest-->access switch --> core stack --> VR...

Can someone Please check my configuration an let me know if it is correct,I want it such that, My Primary ISP works most of the time and all statically mapped IP's are used to access the Internet and server resources.and all others use the dynamic Na...

I purchased several 1921 routers and the last two I setup get the following error during bootup:%SYS-6-READ_BOOTFILE_FAIL: tftp://255.255.255.255/1:aaa1386.bin No usable interfaces.%SYS-6-BOOT_MESSAGES: Messages above this line are from the boot load...

Hello and thanks for any help, this is my issue:We have a business partner with their own separate internal network structure and address block. This partner sends packets to us which we advance on to our clients through various VPN tunnels and then ...

Hi all,I was just here thinking about thinking and I came to this question. Can one company (probably very big) have more than one public AS number?What would be the scenarios where this would be needed? Can you provide real examples?thanks very much...

HI      we started a new branch ,there two link is there one 100mbps and 30 mbps from diffrent vendors. one link is connected to first multilayerswitchand anoter is connected to second multilayer switch..in this two switch i want to configure two def...

Hello Expert,I am trying to configure bandwidth limiting.I am using a workstation with an address defined in object-group Sec_group to send a large file.The file transfer did not show any evidence of been limited from the results, no traffic was been...

Hi All,i Am having a problem at one of my site, for every 2 hrs GBP is reestablished. i found thelog in router:Dec 13 07:41:55.507 CST: %FW-6-DROP_PKT: Dropping tcp session 10.158.186.6:4466129.33.160.116:443  due to  RST inside current window with i...

hi,i would like have a configuration advise with eigrpI have a 3750 at a remote site and Nexus at the core and currently both sites are connected through a fiber running eigrp.I would like to add another layer 2 service connecting between the remote ...

Hi,I am using the cisco linksys E1200 WiFi router.when ever I connect my laptop to WiFi, its show Limited connectivity/Yellow Caution sign when connected. I try to reconfigre it & also in factory default mode it show same.Please help me.Regards,Milan...

Hi Guys,I'd like to configure LDAP support on our several Cisco MDS 9216 and 9222I in our lab,in order for users on our Active Directory domain tpo login to our SAN Switches with their domain credetials.I haven't found any step by step guide. Could y...